mengyao_v10

matlab门限模型，这是一个用matlab做门限模型的一个好的程序。(matlab threshold model, which is a threshold model using matlab to do a good program.)

MATLAB下的语音识别程序，已经做成了gui界面(MATLAB under the speech recognition program, has made a gui interface)

永磁同步电机伺服系统及工件台上位机 软件设计(PMSM SERVO SYSTEM AND HOST COMPUTER SOFTWARE OF WORKPIECE STAGE DESIGN)

低通滤波器，使用FDATOOL，得到滤波系数，然后使用matlab仿真，可以直接运行，可以查看原始波形和滤波后的波形，稍微修改可以移植到嵌入式编程中，本人项目使用(Low-pass filter, use FDATOOL, get the filter coefficients, and then use the matlab simulation, can be run directly, you can view the original waveform and waveform after filtering, a slight modification can be ported to embedded programming, I project uses)

做过模糊PID的朋友很多遇到过这种问题，就是仿真启动不起来，停留在e-7等地方或者仿真很慢，自次上次有个朋友说改变步长能解决这个问题，最后的曲线能达到满足要求的时候，我让他找个例子他就没有后文，以前我做了很多这样的模糊PID，但靠改变步长并没有解决问题，仿真曲线直接发散出去了，我自己这两天也总在思考这个问题，通过不断的调试总结，明白了不少，给遇到这个问题的朋友讲解一下解决办法吧，以一个例子详解：(Done a lot of friends of the fuzzy PID encountered this problem, simulation start up, stay in the e-7 and other local or simulation is very slow, have a friend who said to change the step size to solve this problem since the times the last, the finalcurve to achieve to meet the requirements when I asked him to find examples of his later, I have done a lot of fuzzy PID, but by changing the step does not solve the problem, the simulation curve directly divergence out, Itwo days always thinking about this problem, summarized by the debug and understand a lot of friends to experience this problem to explain the solution, an example Detailed:)

生成一个一定参数的原信号，并附加一个符合均匀分布的随机噪声，分别画出该信号经过均匀采样的频谱图以及经过非均匀采样的频谱和时域图(Generate a certain parameter of the original signal, and attach a line with uniformly distributed random noise were drawn through uniform sampling of the signal spectrum as well as through non-uniform sampling of the spectrum and time domain)

说明：  matlab关于扩展卡尔曼的源程序，有不足之处还请多多指教(matlab on the extended Kalman of the source, there are also shortcomings to a lot of advice)

A good thesis for power flow analysis + DG

许多系统包含了流量问题。例如交通系统有车流量，金融系统有现金流，控制系统有信息流等。许多流问题主要是确定这类系统网络所能承受的最大流量以及如何达到这个最大流量。MATLAB环境下解决最大流问题(Many systems contain a flow problem. Traffic such as traffic system, the financial system has cash flow, information flow control system. Many flow problem is to determine the maximum flow of such systems and how the network can bear to achieve this maximum flow. Maximum flow problem solving MATLAB environment)

SIMULATE OFDM IN A RAYLEIGH CHANEL