keil uvision5 注册机

关于AVR的一个I/O仿真I2C的源程序(On the AVR an I/O simulation I2C source)

说明：  stm32_I2C1602完整驱动程序, 程序能运行，有兴趣的可以看看。(stm32_ I2c1602 complete driver, the program can run, interested can see.)

说明：  A5130是一款图传模块，程序实现了使用stm32作为主控mcu，通过stm32的硬件四线spi总线控制A5130的寄存器实现两个模块之间的正常通信。(A5130 is a graphics module. The program implements the use of STM32 as the main control MCU. It controls the normal communication between two modules through STM32's hardware four wire SPI bus to control the register of A5130. Fast transmission rate, no packet loss)

chenillard en code c pour pic18f

采用定时器，及单片机TM4C123G的PWM模块，产生SPWM波，且波表无需额外生成(The timer is used, and the PWM module of the single chip TM4C123G generates the SPWM wave, and the wave table does not need to be additionally generated.)

利用PID增量式算法调节PWM信号的输出波形，使其更加稳定(Using PID incremental algorithm to adjust the output of the PWM signal waveform, make it more stable)

说明：  msp430芯片内部ad12模数转换程序源码。。(MSp430 chip internal Ad12 analog-to-digital conversion program source code.)

说明：  使用msp430f2012的10位ADC端口进行采样并转换(Use msp430f2012 port 10-bit ADC sampling and conversion)

这段代码包括了基于STM32对简单小车的循迹壁障以及L298N的驱动。并对其中关键部分进行了注释。(This code includes a simple car-based STM32 tracking barrier and L298N driver. And one of the key parts of the notes.)

FlexRay总线控制器MC9S12XF512软件开发参考手册(FlexRay Bus Controller MC9S12XF512 Software Development Reference Manual)