STM32F746-FSMC-SDRAM

用于绘制LLC的增益曲线。把这段代码放到Matlab里，运行，就能够绘制出来LLC的增益曲线了。(This code is used to draw the gain curve of the LLC converter.)

采用STM32单片机制作的CAN双机通信程序，附有说明文档(STM32 MCU CAN produced using dual machine communication program, with documentation )

说明：  利用STM32的LCD可以实现东涛波形的绘制(The LCD of STM32 can be used to draw Dongtao waveform)

基于51单片机的AD7705的调试程序 经验证很好用 和大家一起分享(51 Microcontroller based debugger AD7705 with proven good to share with everyone)

利用0832以及8255等控制小直流电机的转速，实现高速，低速等转换(0832 and 8255, such as the use of a small DC motor speed control, high-speed, low-speed conversion, etc.)

avrmega16的频率计源码，在2m以内误差为1-3hz，1602显示(avrmega16 the frequency of source, in less than 2m error 1-3hz, 1602 show)

The SC-2075 is a desktop signal conditioner that you can connect directly to National Instruments E Series or 1200 Series devices. The SC-2075 has the following features: • Binding posts – Three for ±15 V outputs – Two for 0 to 5 V outputs – Two for measuring analog signals or DC voltages • BNC connectors – Two for analog inputs – Two for analog outputs – One for triggering • Spring terminals – Eleven for analog inputs – Seven for analog controls – Seven for counter controls – Two for TTL-level power and ground signals – Eight for digital input/output (DIO) signals

本程序是芯片AT45DB041B的ISP的模拟编程，是一个比较实用的程序，推荐大家看看。(This program is the chip AT45DB041B ISP s analog programming, is a more practical procedure, we recommend a look.)

基于595的光立方程序及原理图Pcb图，自己动手的指南(A 595 - based light cube program and schematic diagram Pcb, a hands-on guide)

说明：  步进电机控制及系统仿真，关于步进电机的控制算法等介绍。(Stepping motor control and system simulation.The control algorithm of stepper motor is introduced)