tenqui_v74

用Matlab仿真了基于EPC-C1G2标准的RFID阅读器发送模块的PIE编码及ASK调制。(Simulation using Matlab based on EPC-C1G2 standard RFID readers to send the module code and ASK modulation PIE.)

这五个源代码介绍了如何创建matlab GUI以及各种控件的放置调用(The five source code shows how to create a matlab GUI and the placement of the various controls calls )

基于李雅普诺夫稳定性理论的可调增益的模型参考自适应控制，matlab编程。程序可用，且文档中包含原理框图。(Reference adaptive control, matlab programming adjustable gain Lyapunov stability theory-based model. Program is available, and the document contains schematic diagram. )

Matlab for engineering GA, Vectorized Functions

程序对2发2收系统进行SVD算法的仿真。发送信号采用QPSK调制，信道为准静态瑞利平坦衰落信道，引入的噪声为均值为0的高斯白噪声，接收端采用最大似然检测算法，仿真其误比特率特性。(The SVD algorithm simulation program 2 admission system. Send signals using QPSK modulation, channel prevail static Rayleigh flat fading channels, the introduction of noise with mean 0 Gaussian white noise, the receiving end using the maximum likelihood detection algorithm, simulation of the bit error rate characteristics.)

基于MIT律的可调增益MARC,MIT自适应律可用于单个可调参数的情况，也可用于多个可调参数的情况(MIT-based law adjustable gain MARC, MIT adaptive law can be used in case of a single adjustable parameter can also be used in multiple situations tunable)

另一个指纹识别程序，比较全，用MATLAB编的~~~(Another fingerprint identification process, compare the whole, using MATLAB series ~ ~ ~)

分别建立pid控制与模糊PID控制的BLDC仿真模型，对比效果良好(BLDC simulation models of PID control and fuzzy PID control are established respectively, and the comparison results are good.)

这是一个论文中给出自适应均衡的RLS算法的仿真程序(This is a paper given in the RLS algorithm for adaptive equalization of the simulation program)

根据ANSYS分析得到位移时间数据点后，可用MATLAB拟合其衰减曲线(ANSYS analysis based on data obtained after displacement time point, the attenuation curve fitting is available MATLAB)