Micrium_STM32F746G-DISCO_blinky

关于HOLTEK单片机的资料 很全的 短时间就能上手(HOLTEK MCU data is on the short time you can get started the whole)

基于msp430g2553单片机的ADC数据采集程序，同时将采集到的数据存入到flash中，并且可以通过串口发送数据。是不可多得的430代码模板。(Based msp430g2553 microcontroller ADC data collection procedures, and the collected data are stored into the flash memory, and can send data through the serial port. Is a rare 430 code templates.)

Micrium官方移植的uc-OS III到 stm32f746平台，值得参考与借鉴。(This software package is ported to stm32f746 platform by Micrium.)

this project is for using spi port in NXP philips arm microcontrollers

arm板在Linux系统下通过串口与外部设备进行通信(ARMband universal serial asychronous trans)

针对ARM7（周立功LPC2131开发板）读写EEPROM(AT93C46)的程序。(Reading and writing EEPROM (AT93C46) procedures for the ARM7 (ZLG LPC2131 development board).)

说明：  本文首先介绍了JTAG标准和SoC调试技术，研究了基于JTAG的多核SoC调试结构，优化了一种全兼容多核SoC调试结构，使JTAG控制器的互连能配置成多种模式，以实现单核或多核SoC调试；然后在IEEEl 149．1标准的基础上进行了结构化改进，扩展了指令集与寄存器，实现了基于JTAG标准的SoC调试系统；最后进行了SoC调试系统的功能测试与性能分析，测试结果表明本文实现的SoC调试系统比现有的同类调试工具在功能与性能方面都有明显提高。(This paper describes the JTAG standard and SoC debugging technology, research-based JTAG debugging multi-core SoC structure, optimized multi-core SoC debugging a fully compliant structure, the JTAG controller can be configured into a variety of interconnect models in order to achieve a single-core or multi-core SoC debugging then IEEEl 149.1 standard structured on the basis of improved, expanded instruction set and registers, to achieve standards-based SoC JTAG debug system Finally, a functional test system SoC debugging and performance analysis The test results show that the implementation of SoC debug system debugging tools than the existing similar in function and performance are improved obviously.)

PMSM 180°正弦波无位置传感器FOC程序(PMSM 180 sensorless FOC program.)

S3C2440 TEST PROGRAMM

ATMEGA8_ LTC2400 6位半表头程序 LTC2400最高测量电压为5.3V，超过5.3V或反接都会烧掉。 模拟部分供电最好经过7815稳压，最高输入电压不宜超过18V。 模拟电路与数字电路分开供电。 不要使用开关电源或PWM升压、降压电路供电 (ATMEGA8_ LTC2400 6 ½ -digit meter program LTC2400 highest measured voltage is 5.3V, 5.3V or reverse will be burned over. After 7815 some of the best analog power supply voltage, the maximum input voltage should not exceed 18V. Separate analog and digital circuit power supply. Do not use a switching power supply or PWM buck, boost circuitry)