Laguerre

This package implements vectoriel quantization according Self Organizing Map paradigm It allows to : 1. generate a codebook training images set 2. reconstruct a test image according to the generated codebook 3. ute the Peak Signal to Noise Ratio (PSNR) between the test image and the image obtained after quantization 4. estimate execution time of this process

关于导航定位中的卡尔曼滤波程序。X1，X2分别代表经过转换以后的位置X,Y轴的坐标。V1，V2为其相对应的速度。卡尔曼滤波可以使定位数据更加平滑。(Calman filtering program in navigation and positioning. X1, X2, respectively, after conversion to the position of the X, Y axis coordinates. V2, V1 for its relative speed. Calman filter can make the positioning data more smooth.)

用MATLAB语言求解杆的运动，采用线性插值。(Using MATLAB to Solve the rod movement, using linear interpolation.)

粒子群算法（PSO）应用于神经网络优化，采样matlab编程(Particle swarm optimization (PSO) applied to neural network optimization, sampling matlab programming)

这是清华大学出版社胡广书著的《现代信号处理》的Matlab源程序 (This is widely Hu Qinghua University Press book with the "modern signal processing," the source Matlab)

采用DPCA检查运动目标，首先产生SAR回波，采用DPCA方法，对回波中包含的运动目标进行检测(The DPCA Check the moving target, first of all to produce the SAR echo, the use of the DPCA method, the detection of moving targets contained in the echo)

主成分分析，贡献率排序，各成分贡献率，累计贡献率。自己输入数据矩阵和想要的主成分个数，有大量中文注释(Principal component analysis, ranking of contribution rate, contribution rate of each component, and cumulative contribution rate. You enter the data matrix and the number of the principal components you want, with a large number of Chinese annotations)

对单级倒立摆系统的平衡控制问题进行了研究.。首先建立了系统的数学模型 ,然后采用 PID 方法设计控制器 ,最后对控制系统进行了仿真实验研究. 仿真实验结果不仅证明了PID方案对系统平衡控制的有效性，同时也展示了它们的控制品质和特性.。(The balance control of a single inverted pendulum system was focused. First , the mathematical model of the system was built , then the PID method was adopted respectively to design the controllers, at last , the simulation experiments were finished, by the simulation experiment results, not only the validity of the three methods were confirmed , but their qualities and characteristics were shown fully also.)

说明：  用来测试基本的协同过程cooperative,一个协作通信系统的仿真,包括AF,DF协作方式,接收端采用不同的合并方式(最大比合并,选择合并)进行合并.根据接收端不同的接收合并方式进行最优功率分配(Design of cooperative system)

recursive mean-separate histogram equalization