MineSweeper

Flash Mx Secrets, Source Code,Importent Files,The Best Of Flash Scripts And Action Scripts.zip

PIC12F675 内部eeprom程序 加protues 仿真 -PIC12F675 processes in the internal eeprom emulation protues

说明：  4乘4矩阵键盘stm32f103开发板。 消抖。 col列，Pin配置为PP推挽输出模式； row行，Pin配置为Input模式，启用内部上拉电阻(4 times 4 matrix keyboard STM32F103 development board. Shake off. Col column, pin is configured as PP push-pull output mode; Row, pin is configured in input mode, and internal pull-up resistor is enabled)

STM32F401RE的教学课程，有助于不了解STM32CubeMux的学生了解和使用，内含多个实验教程(STM32F401RE teaching course.)

说明：  it680pdf hdmirx mainmcu

说明：  输入椭圆中心和长短轴径; 2. 计算得到中心在原点的椭圆上的第一个点=; 3. 根据公式(1.1.3-2)计算区域1中决策参数的初值为; 4. 在区域1中每个位置处，从开始，反复按照公式(1.1.3-3)更新决策参数，若决策参数小于0则不变，反之加1，一直循环到为止，记第一个满足此条件的点为(); 5. 在区域2的每个位置处，从开始，反复按照公式(1.1.3-6)更新决策参数，若决策参数小于0则不变，反之加1，一直循环到()为止;(Input ellipse center and long and short axis diameter; 2. The first point of the center on the ellipse at the origin is calculated. 3. According to formula (1.1.3-2), the initial value of decision-making parameters in region 1 is calculated. 4. At each location in region 1, the decision-making parameters are updated repeatedly according to formula (1.1.3-3). If the decision-making parameters are less than 0, they will remain unchanged. If the decision-making parameters are less than 0, then add 1 and cycle until the first point satisfying this condition is (); 5. At each location of region 2, the decision parameters are updated repeatedly according to the formula (1.1.3-6). If the decision parameters are less than 0, they will remain unchanged. If the decision parameters are less than 0, then add 1 and cycle until ().)

说明：  利用matlab来实现Maximum Mean Discrepancy（最大均值差异）的计算。(Realization of MMD with MATLAB)

边缘互信息用于衡量融合图像中获得的边缘信息的多少(How much edge information is used to measure the edge information obtained in the fused image)

说明：  这是一个完整的例子，并且能正确运行，谢谢侯老师，并且谢谢平台的支持。(This is a complete example, and can run correctly. Thank you, Mr. Hou, and thank you for the support of the platform.)

说明：  INS解算与反解算,根据一段航迹生成所需要的传感器数据(INS solve and generation)