MFAC

使用matalb软件，利用递推阻尼最小二乘法进行参数辨识，并改变噪声的强度，即 a*ξ(t)（0<a<1），分析、比较一般递推最小二乘和递推阻尼最小二乘方法的优缺点 ；(Use matalb software, the use of recursive damped least square method for parameter identification, and change the intensity of noise, that is a* ξ (t) (0 <a<1），分析、比较一般递推最小二乘和递推阻尼最小二乘方法的优缺点 ；)

this calculates motion compensated image

Lte system level simulation

说明：  power filter with lineare load capasitor

Extracting MFCC features for audio files and removing silence them. Then calculating some statistical functions

modeling of a induction generator

这是一个基于小波变换的二维图相融合算法，是基于医学图像编写的。(This is a wavelet transform based on two-dimensional map of the fusion algorithm is based on the preparation of medical images.)

Simple tcl code for start up in NS_@ simulation

说明：  利用在 MATLAB Simulink 中的 SimMechanics 工具箱，在 Matlab 中搭建了机器人的机构模型，结合运动学数学模型，实现的机器人的运动模拟实验，并且通过末端执行器输入运动参数与输出运动参数的对比，验证了所建立的运动学模型的正确性。最后根据机构的实际限制条件，限制了两个主动臂的最大转动角度，结合正向运动学模型，得到了整个机器人末端执行器的极限运动位置坐标以及整个运动空间(Using the SimMechanics toolbox in MATLAB Simulink, the mechanism model of the robot is built in MATLAB. Combined with the kinematics mathematical model, the motion simulation experiment of the robot is realized. The correctness of the kinematics model is verified by comparing the input and output motion parameters of the end actuator. Finally, according to the actual constraints of the mechanism, the maximum rotation angle of the two active arms is limited. Combined with the forward kinematics model, the limit motion position coordinates and the whole motion space of the end effector of the whole robot are obtained)

the fuzzy c means program !!