js+css3实现立体式图片旋转特效

FIR低通数字滤波器的设计，利用matlab编程语言利用FIR1函数设计低通滤波器。(Design of FIR Low Pass Digital Filter)

everest的cjacker写的make使用心得1-everest

光伏阵列仿真模型 每个模块有6个单体构成，共有6个模块串联(The efficiency of use of solar panels is influenced by many factors. This paper investigates, by experiment, the influence of artificial light and shading on solar panel cells. Firstly, the panel cells are exposed to artificial light of three different power levels. Secondly, the panel cells were shaded by one-quarter, half and three-quarters. Current-voltage and power-voltage characteristics were determined for both cases. Efficiency calculations were done at the maximum power point. It was observed that when the panel cells were exposed to artificial light sources, the power output and efficiency slightly increased and when exposed to shading, there was a significant reduction in power and efficiency.)

LLC的saber仿真，可以根据自己的选择调解参数。(The LLC simulation of SABER)

这里是功率分配文献中经常提到的功率分配，功率控制，功率平均，以及最最著名的注水法的演示程序，是功率分配问题研究的入门程序，对以后的研究有很大的帮助，谢谢支持(waterfilling)

光伏控制器，自动充放电控制12V/10A光伏控制器（ERA-04-10-A）： 额定工作电压：DC12V 最大充电电流：10A 最大放电电流：5A/路（共两路负载） 太阳能组件开路电压：25V 空载电流：<15mA 温度补偿：-20Mv/°C 工作环境温度：-25°C～+50°C 使用海拔：<5500M 控制器尺寸（mm）: 光控电压（25°C）：<=3.3V 过放保护电压（25°C）：<10.8V 过放恢复电压（25°C）：>10.8V 过充保护电压（25°C）：>15.0V 过压保护电压：17.68V 过压恢复电压：14.7V 浮充电压（25°C）：13.4V～13.7V 恢复正常充电电压（25°C）：13.2V 结束正常充电电压（25°C）：15.0V (PV controller, automatic charge and discharge control 12V/10A PV controller (ERA-04-10-A): Rated voltage: DC12V Maximum charge current: 10A Maximum discharge current: 5A/Road (a total of two loads) Solar components of the open circuit voltage: 25V No-load current: < 15mA Temperature Compensation:-20Mv/° C Operating Temperature:-25 ° C ~+50 ° C with elevation: < 5500M Controller Size (mm): light control voltage (25 ° C): < = 3.3V over-discharge protection voltage (25 ° C): < 10.8V over-discharge recovery voltage (25 ° C):> 10.8V overcharge protection voltage (25 ° C):> 15.0V over-voltage protection Voltage: 17.68V overvoltage recovery voltage: 14.7V float voltage (25 ° C): 13.4V ~ 13.7V back to normal charging voltage (25 ° C): 13.2V end of the normal charging voltage (25 ° C): 15.0V)

极化编码的基本原理，经过一定的变换推导出信道极化现象。本文件中分别给出不同点数的信道极化现象。(The basic principle of polarization coding is to derive the phenomenon of channel polarization. In this document, the phenomenon of channel polarization of different points is given respectively.)

高阶累积书籍，包含了双谱，1.5维谱的讲解和编程，值得拥有(High-end accumulation of books, including the bispectrum, lectures and programming 1.5 dimensional spectrum, worth having)

软件编的工具，超级好用 软件编的工具，超级好用 软件编的工具，超级好用-Provision of software tools, super-easy to use software tool made, super easy to use software tool made, super easy to use

档案资料管理系统-file management system