motaifenxi_1

基于傅里叶分析的信号延时测量，采用FFT方法，对同一频率的两个信号进行频谱分析，测得相位差(Delay measurements based on Fourier analysis of signals using the FFT method for spectral analysis of the two signals of the same frequency, the measured phase difference)

详细介绍了遗传算法和群体智能算法程序设计及实例应用(Genetic algorithm and swarm intelligence algorithm was introduced in detail the program design and examples of application )

雷达目标检测 多干扰环境CA和GO的发现概率随SNR变化曲线 成功(Radar target detection probability of finding multiple interference environment with CA and GO SNR curve of success)

说明：  小生境遗传算法工具箱 很不容易才搜索到的 和大家分享啊 希望对大家有用哦(Niching genetic algorithm toolbox is not easy to search and hope to share useful ah oh)

可以实现的功能是：基于未知输入观测器的故障检测算法(You can achieve the function is: unknown input observer based fault detection algorithm)

CSTR模型cstr模型的建立，CSTR模型cstr模型的建立(CSTR model)

DPCM编解码的SIMULINK建模仿真(DPCM codec SIMULINK modeling and simulation)

source code for jssp problem in MATLAb

增量式PID控制算法Matlab仿真程序 设一被控对象G（s）=50/(0.125s^2+7s),用增量式PID控制算法编写仿真程序（输入分别为单位阶跃、正弦信号，采样时间为1ms，控制器输出限幅：[-5,5],仿真曲线包括系统输出及误差曲线，并加上注释、图例）。(Incremental PID control algorithm Matlab simulation program to set up a controlled object G (s) = 50/(0.125s ^ 2+7s), with incremental PID control algorithm simulation program written (unit step input, respectively, sinusoidal signal sampling time is 1ms, the controller output limiter: [-5,5], including simulation system output and error curve curves, plus notes, legend).)

说明：  包括三个.M文件,分别用于处理生成直方图,图象的线形拉伸和均衡化(Of three. M document for the deal to generate the histogram, respectively, the linear image stretching and equalization)