织构程序

利用谐波叠加法编写的matlab脉动风载荷程序，可以模拟高层建筑风载荷(The MATLAB pulsating wind load program written by the harmonic superposition method can simulate the wind load of the high-rise building.)

C++程序编写规范,适合C++中级读者，老外写的一共100条。-C programming specification for C intermediate readers, the foreigner was a total 100.

控制压缩机启动或停止，升速，降速，查看故障返回等。基于stm32c8t6芯片，keil开发环境。(stm32c8t6 keil can ctrol ccmp start or stop .)

基于图像处理的QR码解码技术，并对QR码解码算法进行详细设计与改进(QR decoding technology based on image processing and detailed design and improvement of QR decoding algorithm)

说明：  my work about indonesian education project based learning

说明：  optimal power flow in IEEE 30 bus system with STATCOM

说明：  设计相应的数字逻辑判断以下几种情况： a）确定一个32-bit有符号数大于零 b）确定一个32-bit有符号数小于零 c）确定两个32-bit有符号数相等 d）确定两个32-bit有符号数不相等 e）比较两个32-bit有符号数的大小 画出电路框图，分析复杂度和成本，探讨MIPS指令集分支转移指令的条件比较在硬件实现上可能的优势。(Design corresponding digital logic to judge the following situations: a) Determine that a 32-bit signed number is greater than zero b) Make sure that a 32-bit signed number is less than zero c) Make sure two 32-bit signed numbers are equal d) Make sure the two 32-bit signed numbers are not equal e) Compare the size of two 32-bit signed numbers Draw the circuit diagram, analyze the complexity and cost, and discuss the possible advantages of MIPS instruction set branch transfer instruction in hardware implementation.)

ISA总线资料《ISA System Architecture》(ISA System Architecture)

与CPU1的功能类似,都是与微机线路保护原理程序配合实现CPU2的功能程序-CPU1 function with a similar, are microprocessor-based line protection with the principle of procedural CPU2 realize the function of the procedure

提出了一个新的超声缺陷自动识别系统。该系统采用小波包分解提取超声信号的特征,采用混沌遗传算法来消除冗余和不相关的特征,并采用支持向量机(SVM) 来对缺陷进行识别。-Proposed a new ultrasonic flaw Automatic Identification System. The system uses wavelet packet decomposition extract the characteristics of ultrasonic signals using chaos genetic algorithm to eliminate redundant and irrelevant features, and using support vector machine (SVM) to identify defects.