登录
首页 » C51 » shumaguan

shumaguan

于 2016-06-15 发布 文件大小:19KB
0 191
下载积分: 1 下载次数: 2

代码说明:

  C51单片机例程,通过红外线用按键使数码管显示键值(C51 microcontroller routines, through infrared button digital tube display key)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • MSC121X_Examples
    MSC121X例程rtc wd spi eeprom (MSC121X_examples code)
    2013-05-20 18:56:25下载
    积分:1
  • wljx
    the code for vorticity-stream function method of FVM!(the code for vorticity-stream function method of FVM!)
    2009-07-14 17:34:08下载
    积分:1
  • 智能温度控制器
    当温控开关打开时,若测得环境温度大于设定温度,则继电器吸合 启动电机工作;若测得环境温度小于设定温度,则继电器释放, 电机停止工作;(When the temperature control switch is turned on, if the measured ambient temperature is higher than the set temperature, the relay will suck in. Start the motor; if the measured ambient temperature is less than the set temperature, the relay will be released. The motor stopped working.)
    2019-03-29 11:44:31下载
    积分:1
  • full-waveform-inversion
    变密度声波方程多参数全波形反演策略,比较新的资料(A multi-parameter full waveform inversion strategy for acoustic media with variable density)
    2016-06-17 10:14:44下载
    积分:1
  • 【19】DMA PWM WS2812 GPIO输出16组
    STM32作为主控芯片,72Mhz,利用DMA+PWM实现驱动WS2812,创建16个并行800kBit / s数据流的想法如下: 使用定时器每1.25us创建一个800kHz的时基和一个DMA请求。 使用2个比较模块在低位时间(350ns)和高位时间(700ns)下创建DMA请求 1.25us DMA请求将GPIO端口的所有位设置为高电平 350ns DMA请求将数据从帧缓冲区传输到GPIO端口。如果该位为0,GPIO引脚将变为低电平,否则将保持高电平。 700ns DMA请求将所有GPIO引脚设置为低电平。 重复步骤1到3,直到发送所有位。 这产生脉冲周期为1.25us,脉冲宽度为350ns或700ns的脉冲流,具体取决于脉冲表示的位值,通过DMA将数据传输到GPIO端口意味着每16个LED每位需要一个字(两个字节)。每个LED 24位,每16个LED 24个字(48个字节)。(The idea to create 16 parallel 800kBit/s data streams is the following: Use a Timer to create an 800kHz time base and a DMA request every 1.25us. Use 2 compare modules to create DMA requests at the low bit time (350ns) and the high bit time (700ns) The 1.25us DMA request sets all bits of the GPIO port high The 350ns DMA request transfers the data from the frame buffer to the GPIO port. If the bit is a 0, the GPIO pin will go low, otherwise it will stay high. The 700ns DMA request sets all GPIO pins low. Repeat steps 1 to 3 until all bits have been transmitted. This creates a stream of pulses with a pulse period of 1.25us and a pulse width of either 350ns or 700ns depending on the bit value the pulse represents. Transferring the data via DMA to the GPIO port means that per 16 LEDs one half word (two bytes) is needed per bit. At 24 bits per LED that makes 24 half words (48 bytes) per 16 LEDs.)
    2020-12-15 10:49:13下载
    积分:1
  • Firmware_F405 V1.2
    说明:  本文件为正点原子悟空飞行器源码,ATKflight F405 V1.2版本,编译环境为MDK-ARM-V5,适合于新手学习,配套正点原子飞控器,体验飞控的乐趣(This document is the source code of the Point Atomic Wukong Aircraft, ATKflight F405 V1.2 version, compiled environment for MDK-ARM-V5, suitable for novice learning, matching the Point Atomic Flight Controller, experience the fun of flight control.)
    2019-05-21 18:23:47下载
    积分:1
  • ADC0809
    利用51单片机驱动ADC0809,实现对滑动变阻器的位置读取。(51 Microprocessor ADC0809, read the position of the sliding rheostat.)
    2012-10-16 22:42:40下载
    积分:1
  • BeepLight
    说明:  一个很好用的直流蜂鸣器单片机前台控制程序(a good use of DC buzzer SCM prospects control procedures)
    2006-01-25 10:29:57下载
    积分:1
  • AVR_HMC5883L-GY273
    GY-273三轴电子指南针资料,AVR单片机。(GY-273 three-axis electronic compass data, AVR microcontroller.)
    2016-06-18 20:05:45下载
    积分:1
  • MEGA8-PWM
    MEGA8的PWM输出功能来完成三路PWM波形.doc(MEGA8 PWM output function to complete the three-way PWM waveform. Doc)
    2013-07-05 11:17:34下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载