BPSK通信系统均衡器仿真试验

基于导频的ofdm信道估计算法研究，包括基本的算法思想和解决步骤(Based on the pilot channel estimation algorithm for ofdm research, including the basic ideas and algorithms to solve these)

机器人二维绘图的matlab程序，应该有二十二个字了吧。(Robot dimensional drawing matlab program, there should be twenty-two word of it.)

Ky thua thuy van anh so voi DCT, DWT

In this work, the Mel frequency Cepstrum Coefficient (MFCC) feature has been used for designing a text dependent speaker identification system. The extracted speech features (MFCC’s) of a speaker are quantized to a number of centroids using vector quantization algorithm. These centroids constitute the codebook of that speaker. MFCC’s are calculated in training phase and again in testing phase. Speakers uttered same words once in a training session and once in a testing session later. The Euclidean distance between the MFCC’s of each speaker in training phase to the centroids of individual speaker in testing phase is measured and the speaker is identified according to the minimum Euclidean distance. The code is developed in the MATLAB environment and performs the identification satisfactorily.

MBOC信号的捕获方法BPSK-like的matlab代码实现，其中包括了CBOC信号的产生，捕获过程(Capture method MBOC signal BPSK-like matlab code, including the generation of CBOC signal acquisition process)

MATLAB编写界面很复杂，通过这个文档你能很快的实现(Written MATLAB interface is complex, through this document you can quickly achieve)

matlab编写的用lk算法进行光流计算的程序，很好的例程(lk algorithm using matlab prepared for optical flow calculation program, a good routine)

光波导中光参量放大过程传播到L处的各光波波形图仿数值真matlab代码(Waveguide optical parametric amplification process spread to L is the value of the true light waveform simulation matlab code)

用Matlab/Simulink的高压输电线路仿真模型，得到仿真数据，然后编程实现双端阻抗法测距！仿真结果表明，测距仿真是准侧的(Using Matlab/Simulink simulation model of high-voltage transmission lines to obtain simulation data, and then double-ended impedance programming ranging! Simulation results show that the simulation is quasi-ranging side)

基于SIMULINK的PID控制器设计与仿真 在第二个和第三个环节之间有累加的扰动输入即：在 5 秒时，幅值为 0.5 的阶跃扰动；控制器为Gc(s) ，反馈环节 H (s )= 1。设定值为0 秒幅值 1 的阶跃信号。(SIMULINK-based PID controller design and simulation)