Two-dimensional path planning based on ACO

基于牛顿拉夫逊发 用于电力系统的潮流计算 适合各种节点 (Made based on the Newton Raphson load flow calculation for electric power systems for a variety of nodes)

一个关于matlab的GUI界面的计算器软件(A GUI interface for matlab calculator software)

School management system

卫星姿态控制模型 用于控制算法的验证和仿真(Satellite attitude control model)

光伏电池阵列模型，用于多电池的光伏发电仿真模型的建立(Photovoltaic array model for multi-cell photovoltaic Simulation Model)

it gives brief explanation about Bayesian threshloding

对于matlab初学者来说，想成为matlab编程高手的话，这本书正是你所需要的。(For the matlab beginners, want to become a master matlab programming, then this book is what you need)

该程序用以对2FSK信号调制解调的仿真程序，信道为高斯白噪声，采用FFT方法对其解调(procedures for the right 2FSK signal modulation and demodulation of the simulation program, channel for white Gaussian noise, FFT method demodulation)

混沌映射序列的自相关函数图,用于电机混沌控制(Chaotic maps autocorrelation function map for motor control chaos)

在FFT后信号的频率往往与谱线不相重合，而在两条谱线之间。为了要求得信号的频率、幅值和初始相角，必须要使用修正法来完成。这里给出一种修正法。(After the signal in the FFT frequency spectrum often do not coincide, and in between the two lines. Request for a signal frequency, amplitude and initial phase angle, we must use to complete the Amendment Act. Here are a Amendment Act.)