代码

无线通信网络的发展趋势之一是将各种不同无线接入技术进行融合。多接入选择作为无线资源管理中的关键技术是目前异构网融合的研究热点之一。从用户的利益出发，充分考虑预接入网络的费用、QoS 和稳定性；假定不同的网络运营商之间是彼此竞争的，即没有达成统一的协议，提出了一种结合目标代价函数与层次分析法的动态多接入选择算法。通过对影响因素进行分析和二次判断，建立了网络选择决策模型，仿真结果验证了该算法的正确性与有效性。(Trends in wireless communication network is one of a variety of different wireless access technologies will be integrated. Multi-access radio resource management in selection as the key technology is the integration of heterogeneous networks of research focus. From the user' s interests fully into account the cost of pre-access networks, QoS and stability assumed between different network operators are competing with each other, that did not reach uniform agreement, proposed a combination of objective cost function and level analysis of dynamic multi-access selection algorithm. Through analysis of the factors affecting the judge and the second, the establishment of a network selection decision-making model, simulation results verify the correctness and validity of the algorithm.)

极化码matlab仿真程序,包含各种译码方法（sc译码,scl译码，crc校验scl译码）(matlab simulation of polar codes)

说明：  角速度匹配传递对准matlab仿真角速度匹配传递对准matlab仿真(matlab)

仿真源码包括了多层异构蜂窝网络中基于齐次泊松点过程（HPPP）的建模方法，一篇介绍该模型的12年发表在IEEE trans的论文。以及传统六边形建模方法和信道增益矩阵的计算。(Simulation source code, including the multi-heterogeneous cellular networks based on homogeneous Poisson point process (HPPP) modeling method, a description of the model' s 12-year papers published in IEEE trans. And traditional modeling methods and hexagonal channel gain matrix calculation.)

说明：  6. 在三条径的瑞利信道中，对于OFDM： (1) 请设计一种具体的导引辅助的信道估计方法，用Simulink进行仿真。画出比特信噪比与信道估计均方误差的关系曲线和比特信噪比与误码率的关系曲线。 (2) 设频率已同步，请设计OFDM一种具体的采用循环前缀进行时间同步方法，用Simulink进行仿真，画出比特信噪比与捕获概率的关系曲线。 (3) 设时间已同步，请设计OFDM一种具体的采用循环前缀进行频率同步方法，用Simulink进行仿真，画出比特信噪比与频率同步误差的关系曲线。(6. In the three-path Rayleigh channel, for OFDM: (1) please design a specific navigation-assisted channel estimation method and use Simulink for simulation.The relation curves of bit signal-noise ratio and channel estimation mean square error and the relation curves of bit signal-noise ratio and bit error rate are drawn. (2) if the frequency has been synchronized, please design a specific method of time synchronization using cyclic prefix in OFDM. Simulink is used for simulation to draw the relationship curve between bit-snr and acquisition probability. (3) if time has been synchronized, please design a specific method of frequency synchronization using cyclic prefix in OFDM. Simulink is used for simulation to draw the relationship curve between bit signal-to-noise ratio and frequency synchronization error.)

Driving MOSFET in High-Current, Switch Mode Regulators

voice transformation good algo

一种基于LFM和Barker码复合调制的雷达波形，理论上分析了该低截获雷达波形的组成。通过仿真得到复合调制信号的时域波形、频谱图和模糊函数图，与LFM信号和Barker码信号对比分析对复合调制雷达信号的距离和多普勒模糊函数、截获因子等进行了研究。(A radar waveform based on LFM and Barker code modulation is presented. The composition of the waveform is analyzed theoretically. The time domain waveform, spectrum and ambiguity function of the compound modulation signal are obtained by simulation. The range and Doppler ambiguity function and interception factor of the compound modulation radar signal are studied by comparing with LFM signal and Barker code signal.)

说明：  Performance Evaluation of DWT

采用带通滤波法，对信号进行1/3倍频程分析。程序带详细注释。(no english)