jiejao

设计一个一位二进制数大小比较器。比较两个一位二进制数A和B的大小，电路有三个输出端Y1，Y2和Y3，分别对应A大于B，A等于B，A小于B。当条件满足时，相应输出端为1，否则为0。（A，B用两个脉冲源代替），建立仿真模型并保存。(Design a one binary magnitude comparator. A size comparison of two binary numbers A and B, the circuit has three outputs Y1, Y2 and Y3, respectively, corresponding to the A greater than B, A is equal to B, A less than B. When the conditions are met, the corresponding output is 1, and 0 otherwise. (A, B instead of the source with two pulses), and save the simulation model.)

在MATLAB中使用DSP Builder模块，利用DDS原理产生任意频率的正弦波(sinwave)

BOOT PI CLOSE LOOP CONTOLLER

输入x,y的值，并将它们的值互换后输出。(Enter the x, y values​ ​ , and their values ​ ​ are interchangeable output.)

本文对RLS算法和LMS算法做了比较，说明了在同等条件下RLS算法的收敛速度比LMS的快，给出了仿真结果图。(The RLS alogrithm and LMS alogrithm is compared in this paper,and we can known the convergence rate of the RLS alogrithm is faster than that of LMS,we alse can see the fig of the simulation result.)

matlab program with result

Electromagnetic Simulation using FDTD Sullivan书中的二维时域有限差分matlab程序(Dimensional FDTD matlab program! Dimensional FDTD Electromagnetic Simulation using FDTD Sullivan book)

Vertical Handoff Algorithm

将同频信号用fastICA算法进行分离，其中包括各种调制信号。MPSK，QAM，MASK(The same frequency signal separation algorithm using fastICA, including a variety of modulated signals. MPSK, QAM, MASK)

Runge–Kutta algorithm with matlab