modeshape

说明：  SUI信道的仿真代码，很不错。有兴趣的人可以看看，1-6都有(SUI CHANNEL。very good，)

使用matlab里的函数来提取Gabor小波特征(Matlab function to use in feature extraction Gabor wavelet)

提取镜头参数数的matlab算法，利用棋盘格靶标照片能直接计算出相机内参数(Extraction of lens parameters of the matlab algorithm, using the checkerboard target photos in the camera can be directly calculated parameters)

用MATLAB程序软件完成Z-N法对控制器的参数整定，实现P,PI,PID控制器的分别参数整定，并求出控制器的控制参数Kp，Ti，Td。最后绘制出不同控制器控制下的及参数整定前后的单位阶跃响应图进行比较。(MATLAB program software is used to complete the parameter tuning of the controller by Z-N method. The parameters of P, PI, PID controller are adjusted, and the control parameters of the controller Kp, Ti, Td are obtained. Finally, the unit step response diagram before and after parameter tuning is plotted under different controller control.)

SPIHT的编码与解码程序，在Matlab下运行。可以控制码率(SPIHT codec running under matlab. rate control is also available.)

hurst parameter: 給入一序列的資類，程式會畫出husrt 參數的figure和估計值 例 hurst_expo(sin(0:0.01:5*pi)) (hurst parameter: the sequence into a category of funding, the program will draw the figure and husrt parameter estimates were hurst_expo (sin (0:0.01:5* pi)) )

The ADPCM package is a flexible simulation tool for an adaptive differential encoder and decoder with backward predictor adaptation. It uses an LP-based (Burg) adaptive predictor and a nonuniform quantizer with mu transfer function. It generates the encoded bitstream and estimates the efficiency of a Huffman code for the compressed sequence.

扩展卡尔满滤波算饭与无味滤波算法的比较 结果是无味滤波略微胜出(EKFvsUKF)

说明：  对OFDM和其他无线接入技术在光通信中的应用讲解的非常详细，是学习光纤无线融合的必备参考书籍。。。(OFDM for Optical Communications)

matlab各类命令，随取随用，希望有帮助(matlab various commands, acquired and used, hope that helps)