QPSK_Alamouti2x2_selfE6

CUM200的中文使用说明书，包含CMU200的大部分实用功能(The Chinese CUM200 instructions)

频谱感知，生成采样频率，进行能量检测，采用matlab算法(Spectrum sensing, generation of sampling frequency, energy detection, using matlab algorithm)

Selective mapping algorithm is proposed to reduce the peak-to-average power ration (PAPR) in MIMO-OFDM system. It is proved that the conjugate symbols on two antennas have the same PAPR property with orthogonal space-time block coded (STBC). By using the characteristic, the computational complexity cost and the side information (SI) is significantly reduced compared with the concurrent SLM algorithm. Simulation results demonstrate that the performance of the proposed algorithm outperforms the conventional concurrent SLM algorithm.

说明：  太赫兹通信方面的代码，可以对照相关文献看(Terahertz communication)

说明：  大规模MIMO中采用天线选择来降低系统复杂度和成本，其中包括最优天线选择和递减天线选择，快速天线选择和基于范数的天线选择算法。(Antenna selection is used in large-scale MIMO to reduce system complexity and cost, including optimal antenna selection and decreasing antenna selection, fast antenna selection and antenna selection algorithm based on norm.)

ptz 云台控制软件, 内带C++ 源码(ptz PTZ control software, which brought C++ source)

关于MATLAB GUI 串口通信的调试程序 ，发送好使，接收程序需要自己天加(About MATLAB GUI debug serial communication program)

改程序为应用M语言实现对FDMA系统的设计仿真，包括发送接收端以及用户端的仿真(The program is designed to simulate the FDMA system by using M language, including sending and receiving terminal and user side simulation.)

加窗QPSK-OFDM调制解调，每个OFDM符号采用QPSK调制方式，并画出了时域对比图(Windowed QPSK-OFDM modulation and demodulation, each OFDM symbol using QPSK modulation and a time-domain comparison chart shown)

本文分析了多级维纳滤波器的特性，在加性噪声和二维天线阵列如均匀圆阵、均匀面阵、十字阵等条件和背景下，对信源个数和信源参数估计问题进行了研究，提出了基于多级维纳滤波器前向分解特性的快速参数估计方法，同时提出了基于多级维纳滤波器的二维ESPRIT参数估计方法，该类方法无需协方差矩阵的估计运算及分解运算，计算复杂度较低。另外，还提出了对信源个数的估计算法。(This paper analyzes the characteristics of multistage Wiener filter, in the additive noise and the two-dimensional antenna array such as a uniform circular array, the uniform array, cross array conditions and background, the source number and source parameter estimation problem undertook study, put forward based on Multistage Wiener filter prior to the decomposition characteristics of fast parameter estimation method, at the same time based on Multistage Wiener filter 2D ESPRIT parameter estimation method, the method does not need to estimate of covariance matrix calculation and decomposition, relatively low computational complexity. In addition, also put forward for source number estimation algorithm.)