Uart_Softconsole_projects

国外经典的TCP转串口的程序,VC++编写,有较强的参考价值(Foreign classic TCP to serial program, VC++ write, there is a strong reference value)

模拟串口，可将任意一个IO口作为串口输出进行调试。。。(Simulate serial port can be any one of the IO port as serial output for debugging. . .)

介绍了一种点位运动控制器的设计，该控制器可以控制步进和伺服电机。该运动控制器以 STM32F103 为主控微处理器，实现了电机起停的加减速控制，扩展了 RS485 串行通信接口，设计了限位保护电 路，移植了嵌入式实时操作系统μC /OS-Ⅱ，通过μC /OS-Ⅱ来调度运动控制器的多个任务，设计了串口通信协议， 可以方便组成多轴控制系统.(Describes the design of a point of the motion controller, the controller can control a stepper and servo motors. The motion controller controlling microprocessor STM32F103, acceleration and deceleration control the motor starts and stops, extended RS485 serial communication interface, designed to limit protection circuits, transplantation of embedded real-time operating system μC/OS-Ⅱ μC/OS-Ⅱ scheduling multiple tasks of the motion controller, designed a serial communication protocol, can easily form a multi-axis control system.)

RS-232 通信调试程序，初学者适应。(RS-232 communications debugger, beginners to adapt.)

zigbee-2006串口互发，是TI源码，实现串口通信(zigbee-2006 serial cross-hair, is TI Source, serial communications)

说明：  数控程序传输，主要是三个程序，KND及GSK990m传输软件，Sercom，hmcadcam_Dnc(NC program transmission, there are three main procedures GSK990m KND and transmission software, Sercom, hmcadcam_Dnc)

基于DMmega128开发板的串口通信程序，对于初学者必看！！(For starters based on DMmega128 development board serial communication program, must see! !)

本文件相似的说明了串口发送数据的全部过程。(This document describes the entire process similar to the serial port to send data.)

串口接收无线传感器节点数据，接收的数据进行显示，并通过数据库存储(Serial receive wireless sensor node data, display data received and stored by the database)

此程序是用Matlab来仿真OFDM系统！(This procedure is to use Matlab to simulate the OFDM system!)