ufmc1

引入滑动窗的PTS改进算法。出CCDF图，与未经过处理的原始曲线经行比较(The introduction of the PTS to improve the sliding window algorithm. A CCDF diagram, and has not been dealt with by the original line curve comparison)

Simulation 16QAM-OFDM with mmeory Polynomial PA (Simulation 16QAM-OFDM with mmeory Polynomial PA)

多路复用写的一个可收发数据的串口应用程序(Write a multiplexer can send and receive serial data applications)

基于OFDM系统，实现classen,Moose提出的频偏估计技术，(Frequency offset estimation technique proposed by Classen and Moose based on OFDM sys)

详细的讲述了linux的ip/tcp通信部分的协议栈，对开发很有帮助(Linux detail of the ip/tcp communication part of the protocol stack, on the development of useful)

LLL格基规约的matlab算法程序，能够实现向量的格基规约(matlab code for LLL lattice reduction)

正交频分复用中当调制方式采用QDPSK时的解调程序(Orthogonal frequency division multiplexing modulation when used in QDPSK procedures at the time of demodulation)

说明：  ：载波频率偏移是OFDM系统实现的关键问题之一。分析了OFDM 系统载频偏移估计的2 种算法，即利用循环前缀和训练序列方法。它们均为最大似然估计方法。分别讨论了它们的基本 思想、实现方法和仿真结果。可以看出基于循环前缀算法复杂度较小，精度不高，而基于训练序列 的算法有较高的估计精度，但降纸了系统传输效率。(Abstract：Carrier frequency ofset is one of the key problems in OFDM system．Two foundational methods 。cycling prefix—based and training sequence—based algorithms。to estimate OFDM carriers~equency ofset are analyzed．Then it discusses their basic thoughts。implementing methods and simulation resuits． Finally。merits and demerits of every algorithm are supposed．It concludes that the cycling prefix— based algorithm has less complexity and less precision。and that the training sequence—based algorithm has better estimation performance at the cost of transmission efficiency．)

说明：  完整的rs+卷积编译码程序，可运行通过，并生成误码率曲线图(rs+conv encoding and decoding)

说明：  LMS自适应信道均衡程序以及学习曲线绘制，程序为matlab代码。(LMS adaptive channel equalization process and the learning curve drawing, procedures for the matlab code.)