mui_v22

系统辨识及其matlab仿真 《系统辨识及其MATLAB仿真》附带的光盘注释: 打开系统辨识及其MATLAB仿真程序与剖析夹 ： 1）“ch2,ch5,ch7辨识程序夹”文件夹为第2章、第5章、第7章的7个MATLAB辨识仿真源程序，可直接在MATLAB6.I环境下运行；对应“*.doc文件”是ch2,ch5,ch7的各程序的注释与剖析。 2）“ch3,ch4,ch6辨识程序”文件夹为第3章、第4章、第6章的6个MATLAB辨识仿真源程序，可直接在MATLAB6.I环境下运行；另一部分“*.doc文件”是ch3,ch4,ch6的各程序的注释与剖析。 3) 两个rar压缩文件解压时密码在本书的前言部分。(System identification and matlab simulation system identification MATLAB simulation that came with CD-ROM Note: open system identification MATLAB simulation program and analysis of the folder: 1) " ch2, ch5, ch7 recognition program folder" folder for Chapter 2 Chapter 5, Chapter 7 of 7 MATLAB simulation identification source, can be directly run MATLAB6.I environment corresponds to the " *. doc files ch2,, ch5, ch7 the program annotation and analysis of 2) " ch3, ch4, ch6 identification procedures" file folder for Chapter 3, Chapter 4, Chapter 6 of 6 MATLAB simulation identification source, can be run directly in MATLAB6.I environment another part of the " *. Doc Document ch3, ch4, the ch6' s program annotation and analysis of 3) extract the compressed files in two rar password in the foreword to the book section.)

MATLAB应用程序接口用户指南 初学都作品。还望指点。(MATLAB Application Program Interface User Guide beginner all works. Also look directions.)

根据潜在震源区数据，利用matlab画第五代潜在震源区图，并在鼠标点击位置编号(According to the potential source area data, using matlab draw fifth-generation potential source area map and click on the mouse position number)

这个程序是基于matlab的计算工件粗糙度的轮廓算术平均偏差Ra的值。里面有例程，还有详细的代码注释，希望对各位有所帮助，代码段还有不完善的地方，运行时间过长，会报错，但是逻辑是没有问题的，日后再改进大家可以基于此来书写新的程序，算是抛砖引玉吧(This procedure is based on the calculation of the value of matlab workpiece contour arithmetic average roughness Ra of deviation. There are routines, as well as detailed code comments, you would like to help, there are imperfections in the code segment, at a later improvement, but logic should be no problem, we can be written based on this new program, regarded puts it)

各种升降压斩波电路的simulink 仿真(Buck Chopper variety of simulink simulation)

随机权重粒子群算法，来自来自于《精通MATLAB最优化计算》( pso with random weight)

用matlab/simulink 开发估算电池SOC的基本方法(battery State of Charge calculate method)

good file inverter with matlab

message regarding disperssion effect in communication

用IEEE14个节点，通过matlab编程行电力系统潮流分析，直接运行即可得到结果，与标准符合。(using the matlab do the power system analysis,the system is the IEEE standard 14 nodes model)