Face-Detection-System

说明：  将源文件转成excel格式并对配对合适的保留时间(Converting the source file to excel format and matching the appropriate retention time)

说明：  本项目运行于Linux，是根据交易空间和发电负荷双方的报价，计算交易市场集中出清的程序。数据库使用国产达梦6数据库，数据库接口使用libdcisg_dm.so。(This project runs on Linux. Based on trade space and Generation/Load bids, it clears the trade market and calculates the Generation/Load accepted bids. It use the DM6 database and the DB interface uses libdcisg_dm.so)

图书管理系统用C++编写的图书管理系统，没有使用数据库，用文件读写方式保存(Library management system written using C++ library management system, not using the database stored with the file reading and writing)

角度格式转换，度分秒转度，度分秒转弧度，弧度转度分秒。测量程序设计的基础代码之一(Point format conversion, transfer degrees degrees minutes and seconds, minutes and seconds turn degree arc, arc degree turn every minute. Measurement of program design based on code)

基于FFT的快速SAR分布目标回波模拟算法. 大面积分布目标的合成孔径雷达(SAR)回波模拟需要大量的运算，文中提出了一种合成孔径雷达回波模拟的快速算法，算法利用时域插值和FFTl’来缩减运算量，对于大面积目标回波模拟时，该算法有很高的效率。文中详细分析sinc函数插值所带来的误差以及补偿方法，并在次基础上提出了一种利用增采样插值方法，该方法以增加少量运算为代价，使得模拟精度的大幅度提高。文中比较了传统方法和基于FFTl’的快速SAR分布目标回波模拟算法的模拟结果，证明了这种快速算法确实行之有效。(The simulation of distributed targets is very important to the design of synthetic aperture radar(SAR)sys- tems．Since the end product is SAR images，the echo of SAR signals needs to be simulated and then processed form SAR images，an d the parameters needs to be measured and the perform ance of the images should be，an d then evaluated．The designing parameters of SAR could be adjusted to meet the requirement of users before developing SAR systems，specially in space—bome SAR systems．Th e simulation data is also needed during the developing an d debugging of a space—borne SAR real—time processor．Another purpose of simulation is to supply a great deal of simulation imag es to train image usors of space—bo rne SAR before it launch．)

光伏控制器，自动充放电控制12V/10A光伏控制器（ERA-04-10-A）： 额定工作电压：DC12V 最大充电电流：10A 最大放电电流：5A/路（共两路负载） 太阳能组件开路电压：25V 空载电流：<15mA 温度补偿：-20Mv/°C 工作环境温度：-25°C～+50°C 使用海拔：<5500M 控制器尺寸（mm）: 光控电压（25°C）：<=3.3V 过放保护电压（25°C）：<10.8V 过放恢复电压（25°C）：>10.8V 过充保护电压（25°C）：>15.0V 过压保护电压：17.68V 过压恢复电压：14.7V 浮充电压（25°C）：13.4V～13.7V 恢复正常充电电压（25°C）：13.2V 结束正常充电电压（25°C）：15.0V (PV controller, automatic charge and discharge control 12V/10A PV controller (ERA-04-10-A): Rated voltage: DC12V Maximum charge current: 10A Maximum discharge current: 5A/Road (a total of two loads) Solar components of the open circuit voltage: 25V No-load current: < 15mA Temperature Compensation:-20Mv/° C Operating Temperature:-25 ° C ~+50 ° C with elevation: < 5500M Controller Size (mm): light control voltage (25 ° C): < = 3.3V over-discharge protection voltage (25 ° C): < 10.8V over-discharge recovery voltage (25 ° C):> 10.8V overcharge protection voltage (25 ° C):> 15.0V over-voltage protection Voltage: 17.68V overvoltage recovery voltage: 14.7V float voltage (25 ° C): 13.4V ~ 13.7V back to normal charging voltage (25 ° C): 13.2V end of the normal charging voltage (25 ° C): 15.0V)

说明：  PC与PDA数据交互系统 PC与PDA数据交互系统 PC与PDA数据交互系统(Interactive PC and PDA data system PC and PDA Data interactive system Interactive System PC and PDA data)

读取segy文件，消除多次波 的地震处理运用(segy read documents, eliminating the multiple use of seismic processing)

一个利用PLC编写的工业控制源程序，包括梯形图和组态，很完整，是三层电梯的程序，可以扩展成多层电梯(Prepared using an industrial control PLC source code, including the ladder and configuration, it is complete, is a three-lift procedure can be extended into a multi-elevator)

电力市场下日无功计划优化模型和算法的研究,电力市场下日无功计划优化模型和算法的研究(Electricity Market Day reactive plan optimization model and algorithm research, Electricity Market Day reactive plan optimization model and algorithm research)