storeEnergy

A star 算法求解最短路径问题(A star algorithm for the shortest path problem)

说明：  pmsm转矩预测控制（还有瑕疵，请指正）(Pmsm Torque Predictive Control (with flaws, please correct))

脉冲积累的改善因子和损失的计算，也有积累与非积累的对比关系图(There is also a contrast relation between accumulation and non accumulation in the calculation of pulse accumulation improvement factor and loss)

采用瞬态直接电流控制的整流器仿真，以CRH5动车组车型参数为例(Simulation of transient direct current control rectifier)

说明：  用于计算多普勒频移的函数，MATLAB语言，挺好用。(The function for calculating Doppler frequency shift, MATLAB language, is very useful.)

说明：  三极管放大实验电路，包括固定偏置/分压偏置，需要根据一些参数确定所选用的电阻值，使得三极管工作在放大状态。本程序将电路设计设计成GUI模式，界面上只需要输入电路设计所需参数，根据相关理论推导，给出相关参数的理论值（放大倍数、输入电阻、输出电阻等），指导实验电路搭建。软件搭建在matlab gui上，方便使用 若干参数说明 beta：三极管放大倍数 Ic：集电极电流 Uce：期望CE间电压 UeCof：Re电阻上点电压与Ucc电压比值，一般0.1-0.2 IbCof：Ib上电流与流过Rb1、Rb2电流的比值，一般0.1 ShuntCe：是否有旁路电容(The experiment circuit of triode amplification, including fixed bias / partial voltage bias, needs to determine the selected resistance value according to some parameters to make the triode work in the amplification state. In this program, the circuit design is designed into GUI mode. Only the parameters needed for circuit design are needed on the interface. According to the relevant theoretical derivation, the theoretical values of the relevant parameters (magnification, input resistance, output resistance, etc.) are given to guide the construction of experimental circuit. The software is built on Matlab GUI, easy to use)

fluent UDF编程，主要应用于DPM积灰建模，UDF开源设计程序(it is useful for learner of fluent)

包含多种MATLAB拓扑优化程序，运用SIMP、渐进结构优化方法实现结构的拓扑优化。(A variety of MATLAB topological optimization procedures are included, and the topology optimization of the structure is realized by using SIMP and progressive structural optimization.)

带有储能电池模块的光伏发电系统，储能模块稳定直流母线电压，光伏工作在mppt模式(Photovoltaic power generation system with energy storage battery module, energy storage module to stabilize the DC bus voltage, photovoltaic work in MPPT mode)

说明：  极值理论POT模型阈值选取，matlab代码。(POT model; extreme value theory)