964668

说明：  MATLAB信号检测仿真例子 参数都已知的GLRT检测(MATLAB signal detection simulation example)

pwm整流器的建模仿真，感应双馈发电机系统的仿真，复化三点Gauss-lengend公式求pi。( Modeling and simulation pwm rectifier Simulation of doubly fed induction generator system, Complex of three-point Gauss-lengend the Formula pi.)

多元ldpc编译码matlap程序，采用bp译码算法(Multiple LDPC coding and decoding)

说明：  lms基础算法，已经经过测试，可以通过。(LMS basic algorithm has been tested and passed.)

均匀线阵方向图， MIMO雷达信号建模、波束形成和目标检测(Uniform linear array pattern MIMO radar signal modeling, beamforming and target detection)

labwindows CVI 8.0 下调试通过的gprs，建立过程和udp通讯。(with labwindows cvi8.0,gprs connection had been programmed,and udp test is ok )

说明：  印度尼西亚大学电子学院的的OFDM程序,非常好,(The OFDM program of the School of Electronics at the University of Indonesia is very good,)

产生正弦信号时域波形及频谱，并通过希尔伯特滤波器。其中希尔伯特滤波器有两种产生方式，一是使用MATLAB自带的FDAtool；二是程序编写。(The time-domain waveform and spectrum of sinusoidal signal are generated and passed through Hilbert filter. There are two ways to generate Hilbert filter, one is to use FDAtool in MATLAB, the other is to write programs.)

PCM编码译码的matlab代码，设一个输入量，对其进行通信原理仿真。(The MAT code of the PCM code decoding, set an input quantity, and simulate the communication principle.)

Wireless Information and Energy Transfer for Two-Hop Non-Regenerative MIMO-OFDM Relay Networks