costas

一个用MATLAB编写的，上变频为2.5GHz的OFDM仿真程序，很好用的程序，适合学习OFDM初学者(A MATLAB prepared, the frequency of 2.5 GHz OFDM simulation program, very good procedures, suitable for OFDM beginners to learn)

说明：  5. 在三条径的瑞利信道中，对于直接序列扩频： (1) 请设计DS-CDMA一种具体的码分导引辅助的信道估计方法，接收机分别采用等均益合并、最大比合并。用Simulink进行仿真，画出比特信噪比与信道估计均方误差的关系曲线和比特信噪比与误码率的关系曲线。 (2) 设频率已经同步，请设计DS-CDMA一种具体的单停顿滑动相关时间同步方法，用Simulink进行仿真，画出比特信噪比与捕获概率的关系曲线。 (3) 设时间已经同步，请设计DS-CDMA一种具体的频率同步方法，用Simulink进行仿真，画出比特信噪比与频率同步误差的关系曲线。(5. In three-path Rayleigh channel, for direct sequence spread spectrum: (1) please design a specific code division navigation aided channel estimation method for ds-cdma, and adopt equal-beneficial combination and maximum ratio combination for receivers respectively.Simulink is used to simulate and draw the relationship curve between bit SNR and channel estimation mean square error and the relationship curve between bit SNR and bit error rate. (2) assuming that the frequency has been synchronized, please design a specific single-stop sliding correlation time synchronization method ds-cdma, Simulink simulation, draw the relationship between the bit SNR and the acquisition probability curve. (3) if the time has been synchronized, please design a specific frequency synchronization method ds-cdma, Simulink simulation, draw the relationship between the bit SNR and frequency synchronization error curve.)

基于MATLAB的OFDM系统仿真及性能分析的一篇论文。内含matlab仿真程序，有循环前缀，信道估计。(OFDM based on MATLAB system simulation and performance analysis of a thesis. Intron Matlab simulation program, cyclic prefix, channel estimation.)

这是一个基于OPtisystem下的对于8PSK信号的仿真，可用于通信工程作业的一般仿真系统。(This is a simulation system of 8PSK signal based on OPtisystem, which can be used in general simulation system of communication engineering operation)

说明：  RA码的仿真程序，包括编码器、信道、译码器，参数可配置。(RA code simulation program, including encoder, decoder, channel, parameters can be configured.)

实现20m双绞线有线通讯，一端控制另一端小灯亮暗，反过来，一端发送字符，另一端显示浮点数(Realize 20m twisted-pair cable communication, one end controls the light of the other end, conversely, one end sends characters, the other end shows floating-point numbers.)

包括turbo，polar，LDPC信道编码，交织，QAM，SCMA，MIMO检测，译码等(Including turbo, polar, LDPC, channel coding, interleaving, QAM, SCMA, MIMO detection, decoding, etc.)

基于MIMO系统原理的stcb，空时编码仿真程序(MIMO stcb)

说明：  基于子空间投影的 CSMG 波束形成算法，是一种将子空间投影与波束形成技术相 结合的抗干扰方法。该方法首先构造干扰子空间的正交补空间，再将天线阵列接收到的空时信号矢量向其投影，然后对投影后的输出信号采用具有严格约束最小功率的抽样矩阵梯度（CSMG）算法，在固定方向上进行波束形成，最后捕获、定位及解算出每个波束得到的无干扰数据等，可以有效地抑制干扰信号，同时又可以更好的保留期望信号。(The algorithm of the CSMG beamforming based on subspace projection, which is a combination of the Subspace projection and beam forming technology. Firstly, the data vector received by antenna array is projected onto the interference subspace, which is orthogonal to interference subspace for achieving interference suppression. And then, by using the method of the strictly constrained minimum power sampling matrix gradient(CSMG), after the projection of the subspace, the signal is beamformed in a fixed direction. Finally, for jammer-free data of each beam achieved to capture, locate, solute and so on. The ability of the suppress interference by this method, which can be more effectively, and keep the desired signal better.)

ofdm仿真程序有关信道传输中的多径效应，多普勒频移，时延扩展(OFDM simulation program on the transmission channel of multi-path effects, Doppler frequency shift, delay spread)