doa_signal

绘制了24课GPS卫星围绕地球旋转的动态图(A dynamic map of the rotation of GPS satellites around the Earth in lesson 24 has been drawn.)

Specification for the WiMAX Standard (包括如何用simulink实现,简单易懂)(Specification for the WiMAX Standard (including where What is the purpose of achieving Simulink and easily understood))

说明：  stm32f030 平台 demo code(stm32f030 demo code)

OFDM matlab 水声通信程序，带有水声同步头，OFDM调制解调(OFDM matlab acoustic communication program, the first sync with the sound of water, OFDM modulation and demodulation)

本文以12个例程详细介绍了opnet的使用，尤其适合初学者。(This paper details the 12 routines opnet use, especially for beginners.)

说明：  broadcom公司芯片驱动接口命令行操作指导(Broadocom chip driver operation command line interface instructions)

说明：  生成2KHz和8KHz的混合信号,使该信号通过上述滤波器,观察滤波前后的波形变化和频谱分布情况, 在改信号中加入高斯白噪声,(The mixed signal of 2KHz and 8KHz is generated so that the signal passes the above filter, the waveform change and spectrum distribution before and after filtering are observed, and Gao Si white noise is added to the modified signal.)

争对移动声源采用波束形成进行语音增强，提出一种约束子带波束形成算法。其波束形成器基于一个软约束，其目的是要使波束指向特定的区域即声源方向。而其核心在于首先要进行声源定位，获得尽量准确的方位信息，然后构造软约束条件，用于波束形成。且在此过程中不断跟踪声源的移动情况。在构造的约束条件中，需要知道声源的二维信息，即与麦克风阵列的距离和方向角，“软”体现在对距离和方向角的确定都是在一定范围内的，有待进一步更正。(Between the mobile sound source using beamforming for speech enhancement, a constrained subband beamforming algorithm. Its beamformer based on a soft constraints, the aim is to make the beam point to a specific region that is the direction of the sound source. And its core is the first to sound source location, access to location information as accurately as possible, and then construct the conditions of soft constraints for beamforming. And in the process continuously tracking the movement of a sound source. Structure at the binding conditions, need to know the two-dimensional sound source information, that is, with the microphone array the distance and direction angle, the " soft" embodied in the distance and direction angle of the determination are within the scope must be further corrected .)

光纤放大器模拟程序，包括泵浦功率、光纤增益、光纤长度等参数(fiber amplifier)

本程序是基于LABWINDOWS/CVI 的，主要是通过串口采集下位机信息，然后显示状态信息并通过串口发送命令字节。(The program is based on LABWINDOWS/CVI.It get message from RS232and display status,then send command by RS232.)