登录
首页 » matlab » DFIG

DFIG

于 2021-03-18 发布 文件大小:264KB
0 609
下载积分: 1 下载次数: 114

代码说明:

  基于MATLAB中的Simulink模块中的双馈风机仿真示例,在此基础上重新设定合理的风机、配网及大电网的参数,设计加入四分量叠加法的风速模型。同时设计了110KV电网电压突然下降,在风电场并网点选择不同模式下的仿真结果分析和35KV配网发生三相短路故障时的风电机组输出特性仿真(Based on the simulation example of the doubly fed fan in the Simulink module in MATLAB, the parameters of the rational fan, distribution network and large power grid are reset on this basis, and the wind speed model with four component superposition method is designed. At the same time, the sudden drop of 110KV power grid voltage, simulation results analysis in different modes of wind farm and dot selection and the simulation of the output characteristics of the wind turbine when the three-phase short circuit fault occurs in the 35KV distribution network)

文件列表:

f35v.slx, 91942 , 2017-06-23
three.slx, 91925 , 2017-06-23
f110v.slx, 92004 , 2017-06-23

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Beggs-Brill
    beggs will计算的vb应用,用于计算两相流动态压降(beggs will calculattion)
    2020-07-03 16:00:01下载
    积分:1
  • 微网并网仿真
    matlab搭建的微网并网仿真模型,希望有用(Matlab built microgrid simulation model, I hope useful)
    2017-11-15 14:58:49下载
    积分:1
  • 工程1
    采用MD5加密的采制化三级编码管理系统,对燃煤电厂入厂煤采制化进行管理。(Use md5 encryption for heat-engine English level 3 coding management system)
    2017-08-03 16:47:22下载
    积分:1
  • PSDBPAPower-system-analysis-software
    电力行业专用的潮流计算软件,能够执行复杂的系统潮流计算分析。(Power flow calculation of industry-specific software, can perform complex flow calculation analysis.)
    2020-12-28 16:39:01下载
    积分:1
  • water_co2
    8MPa 下 CO2/H2O质量比96 /4 的物性参数 适用于东芝超临界二氧化碳循环工质(8MPa under the CO2/H2O mass ratio of 96 /4 of the physical parameters for Toshiba supercritical carbon dioxide circulating fluid)
    2017-04-07 10:14:52下载
    积分:1
  • powerflow3
    利用分布式储能进行配电网的电压调节,是一个33节点的配电网(The use of distributed energy storage for the distribution network voltage regulation, is a 33-node distribution network)
    2021-02-07 15:49:55下载
    积分:1
  • integrated5node
    区域综合能源系统中热-电联合建模,通过使用扩展牛顿拉夫逊算法进行统一求解,同时得出系统内热力系统和电力系统的状态参数。(The joint thermal-electrical modeling of regional integrated energy system is solved by using the extended Newton-Raphson algorithm, and the state parameters of the thermal system and the power system in the system are obtained.)
    2021-02-25 19:29:38下载
    积分:1
  • 简单系统静态稳定
    说明:  对于简单的电力系统网络,分析其静态稳定性(For a simple power system network, its static stability is analyzed)
    2019-11-18 20:23:51下载
    积分:1
  • Robust_Optimization
    基于PSCAD平台的建模,关于鲁棒优化,优化了相关物理量(Modeling based on PSCAD software, the content is robust optimization and optimization of relevant physical quantities.)
    2019-03-30 10:38:50下载
    积分:1
  • ganyingdianji
    分别对速度、磁场两个分量进行独立控制。通过控制转子磁链,以转子磁通定向,然后分解定子电流而获得转矩和磁场两个分量,经坐标变换,实现正交或解耦控制(The velocity and magnetic field components are controlled independently. By controlling the rotor flux, the rotor flux is oriented, and then the stator current is decomposed to obtain two components of the torque and magnetic field. Orthogonal or decoupling control is realized by coordinate transformation.)
    2019-01-25 14:52:53下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载