fdct_wrapping_demo_denoise_enhanced

用IGBT元器件进行的三相全控整流桥的仿真电路(Components used for the three-phase IGBT full bridge controlled rectifier circuit simulation)

这是一个关于异步电机无速度传感器的仿真模型，采用参考模型自适应(sensorless control of the IM based on the MRAC)

说明：  用matlab处理图像的入门函数。包括图像读取，图像叠加，增强等。(analysis image signal using matlab method )

基于独立成分分析混合图像盲分离 源码分享(Technology and Research mixed image separation by Independent Component Analysis)

matlab实现的遗传算法和蚁群算法，结合了JwZIYT算法的优点，解决Agzwzah问题，求其最优解的整个步骤，是个不错的程序，调试没有错误 (Genetic algorithm and ant colony algorithm matlab implementation, combined with the advantages ofJwZIYT algorithm to solve Agzwzah problem, the entire step of seeking the optimal solution, is a good program, no error debugging )

运用MATLAB语言编写的连续型霍普菲尔德网络(using MATLAB prepared by the continuous Hopfield network)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

matlab下用FFT求功率谱和幅值谱的代码(Power spectrum and Amplitude spectrum base on matlab)

it a matlab source code to simulate ofdm

空间矢量svpwm控制的matlab仿真模型(Space vector svpwm control matlab simulation model)