ARM应用程序

超声波测距，可以通过串口助手显示，当小于设定值时，显示0，当大于设定值时，显示1(Ultrasonic Ranging, through serial aides showed that when less than the set value, 0, when greater than the set value, indicating a)

For this project you need a 3.7v power supply that prepared by LM317 regulator. So you need MAX232 for connect uart to pc .my AVR chip project is Mega8 that you can program on any Avr chip have 2kbyte rom. In bascom spi hardware don’t work correct, so I have to software spi ,but the software spi configure have low speed into hardware spi.

飞思卡尔16位单片机无线遥控程序，供初学者开发学习(Wireless remote control program)

利用cc2430自带的adc实现模数转换(Achieved by cc2430 own adc analog to digital conversion)

说明：  仿真机床切割,可生产可编辑的轨迹代码,方便操作.(Simulated machine tool cutting, can produce editable trajectory code, easy to operate.)

NRF24L01Information Program(NRF24L01 Information Program)

用共阴极数码管做的密码锁,可修改密码 ( this is a codelock )

合泰单片机，大学生单片机竞赛组委会提供的，必须使用该单片机开发的作品才能评选(holtek mcu )

fluent软件中关于模拟二维流化床的均匀流化作用的程序代码。(the fluent software simulation of two-dimensional fluidized bed uniform fluidization program code.)

关于金鹏LCD12864串行显示的程序，没有复位端。(Jinpeng LCD12864 serial display on the program, there is no reset terminal. )