yprime

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

Bubble blast programs

快速掌握matlab的书籍.matlab实例编程一百个源程序(Quickly learn matlab books. Matlab source code examples of programming 100)

Evolving factor analysis

混沌动力学实例仿真，采用MATLB可以用作研究动力学学习使用(Chaotic dynamics simulation using MATLB can be used to study learning dynamics)

many matlab code with Fftseq ,uniform to gauss AM DSB FM modulation

另外两种计算短傅立叶变换得matlab程序，已经通过，可以用(The other two short-Fourier transform was calculated matlab procedures, has already been adopted, can be used)

有关可变码长的LDPC编码电路的设计与实现和一些相关的英文资料以及文献(LDPC)

磁场定向矢量控制的simulink仿真模型(simulink model with vector control)

实现对探测器FWHM与E拟合函数a/b/c值的求解(Fitting data to get the a,b, and c values in the function of FWHM and E )