HHTcode

说明：  利用C_Builder与Matlab实现实时数据的获取与处理(Matlab using C_Builder and real-time data acquisition and processing)

本程序是功率谱密度的仿真比较,关于三个信号源的具体情况参见《现代数字信号处理导论》上册，P202，习题5。 实验方法：周期图法、自相关法和协方差法。 (this procedure is the power spectral density of the simulation, 3 signal source on the specific circumstances, see the "modern digital signal processing" Introduction to the first volume, P202, Exercise 5. Experimental Methods : Chart cycle, since the correlation and covariance method.)

介绍关于IEEE34-with-wind及其仿真模型(About IEEE34-with-wind and its simulation model)

These are knn algorithm documentations...

A source code which describes sloshing in a 2d tank under sinusoidal excitation

NEWTON RAPHSON COMPLETE CODE

粒子群算法优化支持向量机的惩罚参数c和rbf的参数gamma。(Particle swarm optimization (PSO) optimizes the penalty parameters c and RBF of SVM gamma.)

在Matlab/Simulink环境下实现永磁同步电机的矢量控制仿真。(To simulate the vector control of PMSM in the aid of Simulink)

三相PLL锁相环的闭环系统仿真模型，仿真并分析三相输入信号包含谐波、不平衡、负序和直流偏移时锁相环的锁相结果(Closed-loop system simulation model of three-phase PLL phase-locked loop,Simulation and analysis of phase-locked loop results when three-phase input signals include harmonics, unbalance, negative sequence and DC offset)

rls algorithm applied to adaptive beamforming in smart antennas in circular arrys