FPGA

大疆公司EC60电机驱动程序，STM32F4，MDK环境(Dji company EC60 motor driver.)

硬件资源: 1,DS0(连接在PA8)，DS1(连接在PD2上) 2,串口1(波特率:115200,PA9/PA10连接在板载USB转串口芯片CH340上面) 3,ALIENTEK 2.8/3.5/4.3寸LCD模块(仅支持MCU屏) 4,按键KEY0(PC5)/KEY1(PA15)/KEY_UP(PA0,也称之为WK_UP) 实验现象: 通过按键KEY_UP可以控制定时器AutoReloadTimer_Handle的开启，这个是 周期定时器，一旦开启就会不断的运行，直到按下KEY1将其关闭。按下KEY0 可以打开定时器OneShotTimer_Handle，这是个单次定时器，只会运行一次， 运行周期到了以后就会停止运行，除非按下按键KEY0将其再次开启。(Hardware resources: 1, DS0 (connected to PA8), DS1 (connected to PD2) 2. Serial port 1 (baud rate: 115200, PA9/PA10 connected on board USB to serial chip CH340) 3, ALIENTEK 2.8/3.5/4.3 inch LCD module (only supporting MCU screen) 4. Keyboard KEY0 (PC5)/KEY1 (PA15)/KEY_UP (PA0, also known as WK_UP) Experimental phenomena: The timer AutoReloadTimer_Handle can be turned on by keying KEY_UP. This is The periodic timer will run continuously once it is turned on until KEY1 is pressed to turn it off. Press KEY0 You can turn on the timer OneShotTimer_Handle, which is a single timer and only runs once. The run cycle will stop after that unless KEY0 is pressed to turn it on again.)

分布式电源接入配网对继电保护影响，挺全面的，可以学习下(Affect access to the distribution network for distributed power protection, very comprehensive, and can learn under)

to joint T tubalar in ferati kolamo rades

Sonoff-Tasmota ESP8266 源码文件(Sonoff-Tasmota ESP8266)

程序为STM32 串口UART 使用DMA方式收发数据的实践(how to read data on UART by using DMA when number of bytes to receive is not known in advance.)

PIC16F886控制红外线程序，希望对大家有帮助。(PIC16F886 to control IR program, we hope to help. )

JTAG 调试原理 , 非常的详细.............(JTAG debugging theory, very detailed)

TI公司新型433M无线射频解决方案CC430源码此源码为带AD采样(TI s new CC430 433M wireless RF solutions for the band this source code AD sampling)

考虑电动汽车的出行需求以及电网的波动特性，建立了电动汽车参与削峰填谷的控制策略(Travel demand and the volatility characteristics of the grid to consider electric vehicles, electric vehicles involved in the establishment of a load shifting control strategy)