Multiplelinearregression

it is used to eliminate the harmonic distortion due to non linear load. By Saravanan.J

this file is about solair system

一个简单的BP代码 简单实用 可以自己参考参考(A simple BP code is simple and practical can refer to the reference)

按照给定指标采用模拟低通滤波器（巴特沃思低通）去逼近理想模拟低通滤波器 ，然后通过双线性变换法对模拟滤波器进行数字化，得到数字滤波器 。(Indicators in accordance with a given analog low-pass filter (Butterworth low-pass) to approximate the ideal analog low-pass filter, and then through the bilinear transformation method of digitizing analog filters, the digital filter.)

说明：  一种自适应滑模控制器的MATLAB设计程序(An adaptive sliding mode controller design of the MATLAB program)

基于share memory 为32bit程序同一个提供一个内存现在的内存访问库(Based on a share memory with a memory now 32bit memory access library program)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

Particle displacement code

this is a matlab code with a gui that designs a shaft depending on the type of material needed the loads acting on it and the factor of safety

说明：  这是用matlab编写的对图像边缘模糊化处理，已编译通过。(This is a matlab source code about photo processing Fuzzy edge。)