Fuzzy-PIDcontroller

说明：  Keller压力传感器labview源程序(Keller pressure sensor LabVIEW source program)

数据采集卡采集拉力值，与预先设定的拉力值进行比较，然后PID运算，控制相应的PWM占空比输出，最终控制电机的速度(The data acquisition card collects the pull value and compares it with the pre-set pull value. Then the PID arithmetic is used to control the output of the corresponding PWM duty cycle, and finally the speed of the motor is controlled.)

说明：  可以通过labview读取excel中的数据，可将excel中的数据写入到labview.(The data in excel can be read through labview, and the data in excel can be written into labview.)

声音信号的功率谱分析(LABVIEW8.2),对声信号进行功率谱分析(Power spectrum analysis of sound signals (LABVIEW8.2))

ModBus CRC16校验 LabView程序源码(ModBus CRC16 check LabView program source code)

labview程序调用matlab开发环境，采用matlab运行引擎开发(labview program calls matlab development environment, the use of matlab runtime engine development)

这是labview和数据库应用的资料，对于一些新入门的很有帮助(This is the labview application and information for some helpful new entry)

通过labview实现tcp协议的通信，可以使用虚拟串口和电脑通信(The communication of TCP protocol can be realized by labview. Virtual serial port and computer communication can be used.)

labwindows gpib 例程 操作GPIB设备( labwindows gpib)

基于Labview下 可燃气体浓度监测软件 源码 labview 2010(Based on Labview software under the flammable gas concentration monitoring source labview 2010)