TMD

用于产生指定大小NxN的块，含有edge的信息，可以指定edge的方向。(Generate a directional block with certain edge.)

讲述了有关滑模控制的理路知识，算法基础和工程实际应用，同时也提供了matlab仿真的例子以及相关程序。(About the rational approach on sliding mode control knowledge base and practical application of engineering algorithms and also provides examples of matlab simulation and related procedures.)

说明：  matlab编写的蚁群优化tsp程序，很不错，希望大家喜欢(ant colony optimization matlab prepared tsp procedures, very good, I hope everyone likes)

智能天线中的天线增益matlab仿真程序：输出最大增益随角度的不同而变化(Smart antenna antenna gain in the Matlab simulation program: maximum output gain varies with the angle of the vary)

用matlab编写的龙曲线源程序，可以供大家参考(prepared using Matlab curve source of the Dragon, for your reference)

说明：  6QAM通过带限信道，设码元速率为1000波特，传输信道特性为滚降系数为0.75的滚升余弦频谱的滤波器，试建立测试模型并观察接收信号（等效基带信号）的眼图、星座图和相位转移轨迹图。simulink模型(6QAM through the band-limited channel, located at 1000 baud symbol rate, the transmission channel characteristics for the roll-off factor of 0.75 of spectrum raised cosine filter roll and try to create a test model and observe the received signal (the equivalent baseband signal) of the eye diagram, constellation and phase transfer trajectories. simulink model)

说明：  mATLAB CODE FOR gAUSSIAN KERNEL

Generation of IP Multicast with Synapse.

Matlab双馈异步风力发电机建模s函数 双馈异步发电机模型一直是风力发电研究的重点，而很多论文的仿真根本就没有建电机模型，这样的仿真是很不准确的，matlab中自带了一个DFIG模型，而这个模型是将发电机、变流器等各个部分都建好了，但对研究发电机的人员来说很不实用。我建的这个模型是分析有功无功解耦时搭建的，用的是s函数，便于修改参数。 (s fuction of pmsg)

Multivariable Frequency Domain Toolbox