PSP_500_FW_UPDATE

基于ti f28035实现的感应电机无速度矢量控制，磁链观测为电流-电压模型，开发平台ccs3.3(Implemented as induction machine sensorless vector control,flux observe model is current-voltage model,compiled by ccs3.3)

基于TI公司2812DSP的感应电机无速度传感器控制，是非常有前景的一个方向(The sensorless control of an induction motor based on DSP 2812 of TI, which has a good prospective in research and industry)

该功能是基于DSP的spwm产生程序，在改程序中可以驱动三相逆变桥作为变频电源。(This feature is a DSP based spwm generation process, can drive the change process as a three-phase inverter power inverter.)

ads7844的DSP-TMS320F2812的源代码，已经通过测试过(ADS7844, the DSP-TMS320F2812 the source code has been tested through)

说明：  此文档为采用FPGA实现的以太网MAC层，以及嵌入式的TCP/IP协议栈(this document for the introduction of FPGA Ethernet MAC layer, as well as embedded TCP/IP protocol stack)

continuous time fourier transform

这是一个基于DSP2812的串口通讯下位机程序,通过该程序可以实现和上位机通讯,将上位机的数据读入,设置电机的转矩和转速.挺好的一个程序,供参考.(This is a serial communication based on the DSP2812-bit machine under the procedures, the adoption of the procedures can be achieved and the host computer communications, will host computer to read data, set the motor torque and speed. A very good procedures for reference.)

基于TMS320C66x系列DSP的超大规模FFT实现，可作为《TMS320C66x KeyStone架构 多核DSP入门与实例精解》书中5.3小节的例程使用。(Based on VLSI FFT TMS320C66x series DSP implementation, as a routine use TMS320C66x KeyStone architecture and multi-core DSP Starter instance fine solution, the book section of 5.3.)

writing efficient c code

TMS320F2812和ADS8361接口主程序，c语言编写(TMS320F2812 and ADS8361 main program interface, language c)