-
MATLABzlp
关于遗传算法的源码,用MATLAB实现的,对初学者非常有用。(The source of genetic algorithm, using MATLAB to achieve, is very useful for beginners.)
- 2010-11-24 10:18:50下载
- 积分:1
-
IIR_high_low_bandpass
Iir高通、低通、低通滤波器,能实现对语音信号的浮点滤波(Iir high pass, low pass, low pass filter, to achieve the floating point filtering of speech signals)
- 2011-05-30 10:48:51下载
- 积分:1
-
WaveletEnergySpectrum
Matlab小波能量谱的程序wavelet energy spectrum (wavelet energy spectrum )
- 2020-06-29 17:20:02下载
- 积分:1
-
optimization-computation-
一本不错的关于MATLAB最优化计算方面的书~(A good book on MATLAB optimization calculations to)
- 2012-10-12 15:32:34下载
- 积分:1
-
第五章
说明: 传感器阵列波束优化设计与应用书籍的第五章natlab程序(Chapter 5 matlab program of book Sensor array beam optimization design and application)
- 2020-12-05 12:29:23下载
- 积分:1
-
最大似然
说明: 两种不同的假设:
H1 : 0 xn A fn wn ( ) cos(2 ) ( ) = ++ π θ n=1,2,…,N,f0 为规一化频率
H0 : xn wn () () = n=1,2,…,N
其中 w[n]是均值为 0,方差为 2 σ n 的高斯白噪声,A 已知,样本间相互
独立,信号与噪声相互独立; 相位θ 是随机变量,它服从均匀分布
1 0 2 ( ) 20 p
θ π θ π ?? ≤ ≤ = ??? 其它
1)改变输入信噪比(改变 A 或噪声方差均可),给定虚警概率,画出
输入信噪比与检测概率之间的理论曲线。(注意:理论检测曲线与样本
数有关) 2)改变样本数,用 Monte-Carlo 实验方法得出 PF=0.001 时输入信噪比
与检测概率之间关系曲线(至少三条),并得出结论。 3)改变 M-C 实验次数,样本数不变,用 Monte-Carlo 实验方法得出 PF =0.001 时输入信噪比与检测概率之间关系曲线(至少三条),并得出
结论(Draw the theoretical curve between input SNR and detection probability)
- 2020-01-03 22:32:15下载
- 积分:1
-
am
说明: am modulation in matlab
- 2009-07-10 16:00:15下载
- 积分:1
-
single_rectangle_pulse_ambig
说明: 单个矩形包络脉冲信号的模糊函数的matlab代码(Envelope of a single rectangular pulse signal ambiguity function of matlab code)
- 2008-11-01 21:47:14下载
- 积分:1
-
avi
说明: 本代码作为初学者,读取AVI电影(matlab能读的AVI电影难找),并提取关键祯,做差分(The code as a beginner, read AVI movie (matlab can read the AVI movie hard to find), and extract key frames, so differential)
- 2011-04-06 18:01:51下载
- 积分:1
-
featrue7
提取信号七个基于瞬时信息的特征:零中心归一化瞬时幅度功率谱密度的最大值,零中心归一化瞬时幅度绝对值的标准偏差,零中心非弱信号段瞬时相位非线性分量绝对值标准偏差,零中心非弱信号段瞬时相位非线性分量标准偏差,零中心归一化的非弱信号段瞬时频率绝对值的标准偏差,一个信号段的归一化瞬时频率功率谱密度的最大值,根据信号 QPSK 和16QAM在 XI 轴投影的不同表现,提出特征参数。(extract information based on the instan eous features : In the center is one of the instantaneous rate of the power spectral density of the maximum, is a center to the absolute value of the instantaneous rate of the standard deviation, Non-zero weak signal instantaneous phase of the nonlinear component absolute standard deviation, Non-zero weak signal instantaneous phase of the nonlinear component standard deviation, In the center is one of the non-weak signal of the absolute value of the instantaneous frequency standard deviation, a signal to one of the instantaneous frequency of the power spectral density of the maximum, According to 16QAM and QPSK signals XI axis projection in the different performance parameters raised.)
- 2021-01-24 13:28:43下载
- 积分:1