nuc900-linux-Ethernet

stc51单片机上对04-多路ADC转换-BandGap-模拟串口发送例程(Stc51 microcontroller on the 04- multi-channel ADC conversion, -BandGap- analog serial port to send routines)

51单片机开发步进电机源代码及报告解释说明(a progress of 51MCU introduction)

AD转换芯片源程序。串行模式通信。。带电路(AD conversion chip source. Serial mode of communication. . Band circuit)

STM32通过SPI通信控制ADC采集脑电、眼电、心电数据，并将得到的数据通过串口与蓝牙通信后将其发送至PC端进行处理(STM32 collects the data of EEG, eye and ECG through the SPI communication control ADC, and sends the obtained data to the PC side after communication through the serial port.)

说明：  这是用C语言写的C51的万年历驱动程序 (This is written using C language of the calendar C51 driver)

资料是电力载波模块ZPLC10的说明，资料含有周立功电力载波模块的所有资料，硬件设计与软件通信协议都有，提供参考设计。(Information is power line carrier communication module ZPLC10 data containing all information ZLG power line carrier communication module, hardware design and software communication protocol, providing reference design.)

基于IAR开发环境，野火GPIO 配置文件，包含C和H文件(Based on the IAR development environment, wildfire GPIO configuration file, including C and H files)

2相四线八拍步进电机程序，可以正转反转，加减速(2 phase four line 8 stepper motor)

MAX6675最全的资料，包含C51源程序，芯片介绍，技术文档等(MAX6675 the most complete information, including the C51 source code, chip introduction, technical documentation, etc.)

软件模拟IIC总线读写24C02程序,完整的编译文件，可直接使用。(Software simulation IIC bus, speaking, reading and writing 24 c02 program, complete compile files, can be used directly. )