SileadTouch.fw

ST低功耗MCR stm8l15x 标准固件库，对初学者入门很有帮助(ST' s low-power MCR stm8l15x standard firmware library entry helpful for beginners)

相信大大家都用过DS18B20A，我自己也用手写了个玩玩(Believe that we all used DS18B20A, I have to play with a hand-written)

说明：  仪表 计量部分代码，采用ATMEL芯片，开发环境IAR(Water Meter Measurement and Display Code)

使用51单片机和cc2530模块组成的路由器程序，可以实现收发和存储功能(51 machines use a single product and get the router module cc2530 program)

Cube配置，IAR编写代码，实现4*4矩阵键盘模块的功能(Cube Configuration, IAR Coding, Implementing 4*4 Matrix Keyboard Module Function)

说明：  设计一个正弦信号发生器，使用凌阳公司的16位单片机SPCE061A作为中央控制器，结合DDS芯片AD9850，产生0～15MHz频率可调的正弦信号,正弦信号频率设定值可断电保存；使用宽频放大技术，在50Ω负载电阻上使1K～10MHz范围内的正弦信号输出电压幅度VP-P=6V±1V；产生载波频率可设定的FM和AM信号；调制信号为1KHz的正弦波，调制信号的产生采用DDS技术，由CPLD和Flash ROM加上DAC进行直接数字合成；二进制基带序列码由CPLD产生，在100KHz固定载波频率下进行数字键控，产生ASK，PSK信号。(Design of a sinusoidal signal generator, the use of Sunplus 16-bit MCU SPCE061A as the central controller, combined with DDS chip AD9850, have adjustable frequencies 0 ~ 15MHz sinusoidal signal, sinusoidal signal frequency settings can be stored power using broadband amplification, in a 50Ω load resistor to 1K ~ 10MHz sinusoidal signal within the output voltage amplitude VP-P = 6V ± 1V generating the carrier frequency of the FM and AM can be set signal 1KHz sine wave modulation signal, modulated signal generation using DDS technology, coupled by the CPLD and Flash ROM DAC for direct digital synthesis binary baseband sequence code generated by the CPLD in a fixed carrier frequency 100KHz digital keying, resulting in ASK, PSK signals.)

51单片机C语言学习，C语言来编写单片机程序。Proteus仿真。(51 MCU C language learning, C language to write MCU program. Proteus simulation.)

说明：  使用STM32单片机驱动dds模块，这里的dds模块为正点原子的模块(Using STM32 MCU to drive the DDS module, where the DDS module is the module of positive atom)

说明：  随着人们对光谱测量仪器灵活性、 微型化的要求 ,便携式光纤光谱仪在实际生产测量中的需求也越来越大 ,对其测量性能的要求也越来越高。根据光纤光谱仪的测量原理 ,利用波长与CCD探测器单元格一一对应的关系 ,提出了一种波长校正的方案 ,波长校准精度可以达到0.5nm ,重复性达0.1nm。(Wit h people′ s requirement for spect rometer are agility and micromation , portable fiber spect rometer is needed more and more widely in practical measurement , and t he requirement for it s measurement capability get s more and more higher . According to t he measurement principle of t he fiber optic spect rometer and the cor responding relationship between t he wavelengt h and the CCD detector′ s cell , a wavelengt h correction met hod is p ut forward in t his paper , t he wavelengt h p recision can reach 0. 5nm and t he repeatability can reach 0. 1 nm.)

数字电源控制,128*64液晶驱动显示.(Digital power control, 128* 64 LCD display driver.)