EVcharger_AverageModel_pu

无线充接收端的程序，加入PI调节，合乎QI协议(wireless charger receiver)

对于新手调试入手很快,通过32单片进行通信控制,及算法运算。(For beginners, debugging starts very quickly, communication control is carried out through 32 single chip, and arithmetic operation is given to them.)

脉冲计数器，用c语言实现，并将计数结果用led显示出来。(Pulse counter, using c language, and count the results with the led display.)

说明：  假设P1.0口为发光二极管（共阴），其通过按键来控制是否开启(Suppose that the P1.0 port is a light emitting diode (common negative), which controls whether to turn on or not by pressing a button.)

GD32(Cotex-M3内核)的ADC实验示例程序，完成芯片内核AD的采集及显示屏的显示(GD32 (Cotex-M3 core) of ADC experimental sample program, the completion of the acquisition and chip core AD screen display)

2路18B20采集程序，读取两路温度，两路温度同时利用单总线原理读取内部温度并显示在1602上(2-way 18B20 acquisition program that reads two temperature, two temperature while using the principle of a single bus read the internal temperature and display in 1602)

说明：  使用51单片机和HTTP通信,运用AT指令实现，每一次发送指令都会返回OK否则不执行下一步。(Use 51 single chip microcomputer and HTTP communication, use AT instruction to achieve, each time send instruction will return OK or not to execute the next step)

DL645协议解析程序，调试通过，需要的朋友可以下看看，有什么问题欢迎讨论。(DL645 protocol parser, debugging passed by the friends can next see any problem welcome to the discussion.)

采用STC12C5A60S2单片机发生47KHZ的PWM脉冲信号，经过IR2104控制MOS，从而控制整个BUCK电路。单片机内部自带的10位ADC能通过电压电流检测电流实时反馈电流和电压数值，并由此调整输出的PWM的占空比，形成电流电压闭环控制系统。按键能设置输出电流从0.2A到2A，以0.01A递增，输出最大10V，液晶能显示实时输出电流与电压(use STC controller to generate pwm signal ，whic can dribe mos pipe，then control buck circuit)

STM8S_StdPeriph_Lib_V2.3.1 官网驱动包(STM8S_StdPeriph_Lib_V2.3.1 official driver pakcage)