LABVIEW-HHT

该vi主要是一台简单的单通道数字示波器，实现数据采集、波形显示、信号处理、波形存储等(The main vi is a simple single-channel digital oscilloscope, data acquisition, waveform display, signal processing, waveform storage, etc.)

NewPort平移台ESP301的控制程序，根据说明书自己编写的，不当之处请指正，串口通信，附有说明书。(Cord for Newport ESP301.)

用LABVIEW做的串口通讯无线温度（DS18B20）采集系统，可以实现对温度数据的采集，波形显示，报警，数据回放和数据保存功能。程序简单易懂，送给有需要的同学学习~(Serial communication using LABVIEW to do wireless temperature (DS18B20) acquisition system, you can achieve the acquisition of temperature data, waveform display, alarm, data playback and data retention. Program is easy to understand, give students need to learn ~)

说明：  故障检测，火车故障检测系统，labview实现(Fault detection, train fault detection system, LabVIEW implementation)

labview与OPC通讯以欧姆龙NJ501PLC为例，希望能对大家有帮助。(Labview communicates with OPC)

空调的Labview的界面编程，界面显示从电机传出的数据，如电流、电压(Air conditioning of the Labview programming interface, interface display data coming from the motor, such as current voltage )

labview的PXI应用实例，通过工程实例详细介绍了PXI虚拟仪器的使用。(PXI using in labview)

说明：  基于LabvIEw的通用自动测试系统(ATs)舍计算机，可鳊程激励、响应数据采集及uuT模块，采用MxI总线控制方式。专用信号发生器为uuT提供模拟激励信号，矩阵开关和适配器完成不同信号间切换。主控计算机执行测试程序，信号发生器发送激励信号，数据采集卡采集数据，采集数据经调理后，并与标准数据|匕较是否满足相应测试结果。(The general automatic test system (ATs) based on LabvIEw can be used as a computer to excite, respond to data acquisition and uuT module. The control mode of MxI bus is adopted. Special signal generator provides analog excitation signal for uuT, matrix switch and adapter complete switching between different signals. The main control computer executes the test program, the signal generator sends the excitation signal, the data acquisition card collects the data, after the data acquisition is adjusted, and compares with the standard data | dagger whether it meets the corresponding test results.)

登陆界面，输入密码进入主程序，主程序是初建的家庭账单(LOGON require password)

labview中对串口进行操作，注意：这不是普通的操作方法，而是使用队列的方法，避免了数据乱串的象限。(labview visa queue control)