lpc1700

stm32f030工程源码，原子风格代码(stm32f030 project source code, atomic style code)

这是应用于 windows ce 4.2平台上串口接受的程序，我已经实践过，好用，也可以根据它修改出发送程序(This is used in windows ce 4.2 platform serial port to accept the procedure, I had already been put into practice, use can also be sent out according to its modified procedures)

基于三星ARM7程序开发,最经典的程序设计.由BOOT程序导入工作程序.(Samsung ARM7-based program development, the most classic programming. By the BOOT program to import procedures.)

采用stm32内部TIM编程 实现对输入信号的计数测频 可测0HZ—65536HZ的频率(TIM programming using the internal stm32 Count the input signal to achieve frequency measurement Can be measured 0HZ-65536HZ frequency)

arm11 初学源代码 有些事自己完成 有些是经过修改的。希望对大家有帮助(arm program.)

本历程实现了一个完整的层次状态机HSM，可根据UML方便的写出相应的状态机代码。特别适合复杂状态机的开发。(This process implements a complete hierarchical state machine (HSM), according to the UML state diagram convenient to write the corresponding state machine code. Especially for complex state machine development.)

ARM嵌入式WINCE教程 platform builder安装 EVC使用实例(ARM for wince)

stm32f103zet6读写EEPRAM的例子，固件库是V3.5版本的(stm32f103zet6 read EEPRAM example, firmware version V3.5 library is)

STM32F103 LTC4150电源管理 把电量和电量百分比放到stm32的内部flash中。(STM32F103 LTC4150 power management to power and the percentage of power into stm32 internal flash.)

ATMEGA8_ LTC2400 6位半表头程序 LTC2400最高测量电压为5.3V，超过5.3V或反接都会烧掉。 模拟部分供电最好经过7815稳压，最高输入电压不宜超过18V。 模拟电路与数字电路分开供电。 不要使用开关电源或PWM升压、降压电路供电 (ATMEGA8_ LTC2400 6 ½ -digit meter program LTC2400 highest measured voltage is 5.3V, 5.3V or reverse will be burned over. After 7815 some of the best analog power supply voltage, the maximum input voltage should not exceed 18V. Separate analog and digital circuit power supply. Do not use a switching power supply or PWM buck, boost circuitry)