qcom-spmi-iadc

pic18f452 TMR1的RTC功能——秒信号发生器(pic18f452 TMR1 the RTC function- second signal generator)

Control module for a Sony projector

STM32加ESP8266模块，实现UDP透传模式通信，可以通过SHELL命令，获取采集电压和时间信息。在UDP调试工具输入“getcfg”可以获取配置信息 包括单次测量模式 循环测量模式 循环时间间隔设定等等相关参数设置。(STM32 and ESP8266 module are used to achieve UDP transmission mode communication, and the acquisition voltage and time information can be obtained through the SHELL command. In the UDP debugger, input "getcfg" can get configuration information, including single measurement mode, cycle mode, cycle interval setting and so on.)

msp430f5438 multi level menu

用MSP430F203微控制器为核心构建的控温电热毯。以一个Pt1000热电阻作为传感器，用PID算法以PWM的方式控制加热输出，并通过一个共阳RGB LED显示多种设定和测试温度。通过Timer_A2构建了一个全双工串口与PC通讯。(A heat-blanket application by MSP430F2013 microcontroller. Sensor RTD Pt1000 measure the temperature, and a PWM output control heating power. Just one key is engaged to set the temperature. A common anode RGB three-color LED is used to indicate the setting temperature and the measured temperature. A full duplex serial port module is fulfilled by the Timer_A2.)

这是一份关于MSP430的C程序和课件，虽然不是很全面，但是对于新手还是够用的。(This is a report on the MSP430 C program and courseware, though not very comprehensive, but still enough for the novice.)

学内燃机的都懂，不用多介绍了，kiva-3v做模拟仿真必备。(Understand about learning the engine, do not introduce more, kiva-3v necessary to do simulation)

MB85RC64驱动程序。使用I/O模拟I2C，可直接修改使用。(MB85RC64 driver.Use I/O simulation I2C, can be directly modified to use.)

新唐NUC1XX系列CONTEX-M0 CPU BSP文件。(New Tang NUC1XX series CONTEX-M0 CPU BSP file.)

51单片机 做一个简易的存储示波器的程序清单(51 single-chip storage oscilloscope with a simple list of procedures)