PowerFlow1

可用于如单相接地故障的仿真研究，观察考虑电弧影响的波形(It can be used in the simulation research of single-phase grounding fault, and observe the influence of arc)

This is modulation of windfarm Doubly Fed Induction Generator using PSCAD.

电力系统潮流程序，适合初学者.含读取数据文件，形成节点导纳矩阵，形成雅可比矩阵等所有计算过程的程序。(power flow )

5个重要的UDF源码： 1、水波动态模拟的动网格UDF 2、UDF定义液滴撞击过程 3、hoff方法的动态接触角UDF 4、平衡方法的动态接触角UDF 5、钻头运动的动态模拟的动网格UDF (Five important UDF source: 1, dynamic wave simulation of dynamic grid UDF 2, UDF definition of liquid droplets impinging process 3. Hoff method of dynamic contact angle UDF 4, balancing method for dynamic contact angle UDF 5, drill movements of the dynamic simulation of the dynamic grid UDF )

光伏模型 扰动法MPPT 逆变器采用电压-频率控制(Photovoltaic model P&O method MPPT The inverter adopts voltage frequency control)

IEC101-104 电力规约通讯实现及测试软件，VC2003下编译运行通过。支持串口以太网(IEC101-104 power protocol communication and testing software, VC2003 compiler run through. Support serial port Ethernet)

说明：  应用于电力系统最优潮流计算，使用的是原对偶内点法(Optimal dual power point method for optimal power flow calculation)

说明：  电力电子基础内容，整流部分的单相半波整流电路(single-phase half-wave)

求取两个信号的到褶积，通常在用地震方法找油气中用雷克子波和反射系数求取褶积，本程序只是搭建了一个大致的框架，如果需要的到结果，还需要自行设置信号和一些参数。(Strike to the convolution of two signals, typically using seismic methods used to find oil and gas Ricker strike wave and reflection coefficient convolution, this procedure is to build a general framework, if the desired results, you need to set your own signal and some parameters)

说明：  建立了风电场模型，可用于多情情况下的风力发电仿真(Established a wind farm model that can be used for wind power simulation in arousal situations)