spc3-STM32

永磁同步电机的dsp控制，详细注释，适合初学者使用(Permanent magnet synchronous motor dsp control, detailed notes, suitable for beginners to use)

CCS4.2破解指南，自行编写，绝对可用，成功率100 (CCS4.2 crack guide, write your own, absolutely free, 100 success rate)

这是有关dsp实验的FFT的算法实现和仿真。(This is the DSP experiments FFT algorithm and simulation.)

DSP28335,UCOS系统移植,带有流水灯程序,在CCS6.0环境下编译使用(DSP28335,UCOS,RTOS,WATERLIGHT，ccs6.0，TI)

利用28335芯片，采集hall传感器采集相关信号，驱动pmsm电机(The 28335 chip is used to collect Hall sensors to collect relevant signals and drive PMSM motors.)

这是一篇老外写的介绍ofdm系统设计的文章,含有c及asm代码,在TMS320C5510上实现，很有参考价值！(This is the introduction written by a foreigner OFDM system design article, containing c and the asm code, in the TMS320C5510 realize, a good reference!)

dsp28335pwm已测试通过~~整体文件(dsp28335 epwm_dma Prototype statements for functions found within this file. Device Headerfile and Examples Include File )

通过AD校正来提高2812 AD采样的精度，AD采样频率为10K，序列发生器SEQ1和SEQ2级联成一个16通道的序列发生器，采样模式采用顺序采样。利用通用定时器T1的周期中断事件来启动AD转换。(By AD 2812 AD correction to improve the accuracy of sampling, AD sampling frequency of 10K, the sequence generator SEQ1 and SEQ2 cascaded into a 16-channel sequencer, sampling mode with sequential sampling. The use of general-purpose timer T1 period interrupt event to start AD conversion.)

1、ADC用于DMA模式，TIM3的TRGO触发，ADC等时间采样 2、TIM2的1、2通道用于捕获 3、TIM1的第一路，用于SPWM，使用的是对称规则采样法，此方法计算量较小(1, ADC for DMA mode, TRGO TIM3 trigger, ADC and other time sampling 2, TIM2 1,2 channel for capturing 3, the first road TIM1 for SPWM, using a symmetric regular sampling method, this method of calculating the amount of the smaller )

dsp 方面的知识，拿来大家多学习学习，共同提高，共同进步(dsp knowlege)