LabVIEW-Report-Demo

Determine the tone of a given signal.

介绍了Labview编程中的堆栈技术，提供demo案例。(This paper introduces the stack technology in Labview programming and provides demo cases.)

在labview使用超声波传感器和红外传感器进行距离的监控，本程序监控了5个超声波传感器。(In the use of LabVIEW ultrasonic sensors and infrared sensors for distance monitoring, this program monitors 5 ultrasonic sensors.)

研华板卡的上位机labview程序，适合labview入门(upper computer labview program based yanhua company)

数据采集卡采集拉力值，与预先设定的拉力值进行比较，然后PID运算，控制相应的PWM占空比输出，最终控制电机的速度(The data acquisition card collects the pull value and compares it with the pre-set pull value. Then the PID arithmetic is used to control the output of the corresponding PWM duty cycle, and finally the speed of the motor is controlled.)

Labview，数据采集例程，带子VI，(Labview, data acquisition routines, have SubVI)

说明：  Indoor_VLC_Ray_Tracing. MATLAB-based open-source software for generating indoor visible light communication impulse response

使用labview编写的灰色预测程序，判断设备故障的类型，程序已经调试通过。(LabVIEW prepared using gray prediction procedure to determine the type of equipment failure, procedures have been debug through.)

基于LABVIEW的数据采集的框图程序，用于采集信号数据并保存(Of the block diagram of data acquisition based on LABVIEW program, used to collect signal and save the data )

这是一个QPSK的调制及解调过程的例子，供大家学习参考(This is the example of a QPSK modulation and demodulation process for them to learn from the reference)