Wind-power-bearing-test

基于MATLAB_SIMULINK的并网型双馈风力发电机仿真模型的研究(MATLAB_SIMULINK grid-type double-fed wind turbine simulation model)

Labview制作的倒立摆仿真试验，大家可以参考一下(Labview produced inverted pendulum simulation, we can refer to)

TI dsp的spi编程例子，基于keystone架构，很好的入门资料(example of program spi in dsp )

说明：  定时器中断典型例程,介绍了定时器中断的寄存器配置，编写理定时器中断代码，供程序设计参考。(Timer interrupt typical routine, introduces the register configuration of the timer interrupt, writes the timer interrupt code, for program design reference.)

DSP2812的CAN通讯例程，可兼容CCS3.3开发环境，(DSP2812 CAN Communication Code, Compatible CCS3.3 development environment.)

是信号处理方面欠采样的源程序 ,是很不错的程序,可以这方面的学者一些参考价值(signal processing is owed sampling of the source, is a very good procedure, which some scholars regard the reference value)

对于无法实现硬件定时的数据卡来说，这个vi提供了软件定时的功能(For data cards that cannot achieve hardware timing, this VI provides software timing capabilities)

pid在dsp6713中详细使用的应用源代码程序。(the pid code used in the DSP6713)

使用labview编程实现的串口通信，通过串口发送的命令控制相关设备进行数据传输和处理(Serial communication using LabVIEW programming, data transmission and processing through the serial port to send commands to control devices)

使用飞思卡尔DSP8037的风光互补发电可控升压整流电路原理图与PCB图(Use of wind and solar power generation Freescale DSP8037 controlled boost rectifier circuit schematic diagram and PCB)