WAVELET-FOR-NDT

该程序用以对2FSK信号调制解调的仿真程序，信道为高斯白噪声，采用FFT方法对其解调(procedures for the right 2FSK signal modulation and demodulation of the simulation program, channel for white Gaussian noise, FFT method demodulation)

在已知天线阵列的单元个数和要求的腐瓣电平时，利用切比雪夫加权，求的各个阵子的激励幅度(In the known antenna array of the number of elements and requirements rot lobe usually use cut weighted Chebyshev, seeking incentive rate for each time around)

在matlab环境下，实现了用sweldens算法对一维信号作分解和重构的程序(In the matlab environment, achieved by sweldens algorithm for one-dimensional signal decomposition and reconstruction procedure)

（7，4）汉明码的编译码程序，基于MTLAB语言(Encoding and decoding procedures of （7，4）Hamming code)

利用分步傅立叶积分法，计算了光纤中色散与SPM效应(Step-by-step use of Fourier integral method, the calculation of the fiber dispersion and SPM.)

说明：  描述了matlab的程序设计语言的编写、实例、有利于初学者使用。(Describes the matlab programming language, for example, writing for beginners.)

电力系统3机系统的暂态稳定仿真程序，子程序为故障前故障中和故障后三个状态(System for power system transient stability simulation program, subroutine, three failures before the failure and fault status)

CS仿真此仿真详细的列出了仿真的过程，并给予文字说明，是初学者的好资源！(CS simulation)

a new clustering algorithm source code in MATLAB

对AR（4）模型的经典功率谱估计，并与真实功率谱作比较。采用了welch方法，协方差法，burg方法(For AR (4) model of the classic power spectrum estimation, and with true power spectrum for comparison. Welch method using covariance method, burg method)