3.DCT

simulink的仿真有两个阶段：一个为初始化，这个阶段主要是设置一些参数，像系统的输入输出个数、状态初值、采样时间等；第二个阶段就是运行阶段，这个 阶段里要进行计算输出、更新离散状态、计算连续状态等等，这个阶段需要反复运行，直至结束。(simulink simulation has two phases: one for initialization, this stage is mainly to set some parameters, such as the number of input and output system, initial state, the sampling time second stage is the operational phase, the Stages to calculate the output, update the discrete state, continuous calculation of the state, etc., this stage requires repeated runs to the end.)

image match using in engineering and get information from object

VLSI electronics books for technical studiesVLSI electronics books for technical studiesVLSI electronics books for technical studies

利用摄动方法计算高斯粗糙表面的te、tm反射率(computes the TE and TM emissivities from Gaussian rough surface using the small perturbation method )

A*算法 机器人路径 单机器人路径 多机器人路径规划算法(A* algorithm for robot path of a single robot path to multi-robot path planning algorithm)

PLS FOR EVENT RELATED fMRI

说明：  输入一个数判定能否开平方，能就开平方，不能就退出(Enter a few decide whether to open the square, to the open square, can not quit)

FFT变换及逆变换，用FFT进行简单滤波，自功率谱和互功率谱(FFT transform and inverse transform, a simple FFT filter, auto power spectrum and cross power spectrum )

说明：  welch 法加汉宁窗对高斯白噪声信号进行功率谱分析(welch Fajiahanning window on the Gaussian white noise signal power spectrum analysis)

Code for synchronization research. You can make synchrogram from two phase data.