-
logbinpdf123
Estimate pdf of data set spanning orders of magnitude
- 2010-10-28 17:43:45下载
- 积分：1
-
non-constrant
解决无约束多维极值问题的matlab源码(non-constrant )
- 2010-01-09 10:08:21下载
- 积分：1
-
LTE_for_4G_Mobile_Broadband_Air_Interface_Technolo
无线空中接口《LTE_for_4G_Mobile_Broadband_Air_Interface_Technologies_and_Performance》(Wireless air interface " LTE_for_4G_Mobile_Broadband_Air_Interface_Technologies_and_Performance" )
- 2010-01-14 10:18:36下载
- 积分：1
-
normal_beamforming
说明： 该程序为常规波束成形的程序，在计算机上已经运行过了，可以正常运行。(The program for the conventional beam-forming process, the computer has to run off, and it works.)
- 2010-04-17 21:24:27下载
- 积分：1
-
mfcc
mfcc 的matlab的实现，此方法在matlab上运行成功(mfcc the matlab realization this method successfully run in matlab)
- 2013-04-13 13:26:16下载
- 积分：1
-
fenceng
对小波信号进行去噪处理，主要采用分层重构，软硬阀值的方法进行仿真。(To deal with the noise of the wavelet signal, mainly adopts hierarchical reconstruction, hard and soft threshold method are simulated.
)
- 2015-06-13 22:10:58下载
- 积分：1
-
newICA
一种新的ICA算法，能够很好地对一维信号进行盲源分离，并有例程(A new ICA algorithm, very good to be able to one-dimensional signals, blind source separation, and have routine)
- 2009-03-02 10:08:21下载
- 积分：1
-
PMSM_SVPWM_2
永磁同步电机svpwm控制matlab/simulink仿真图(Svpwm permanent magnet synchronous motor control matlab/simulink simulation map)
- 2014-11-18 14:30:28下载
- 积分：1
-
MIMO-OFDM-Simulator
多输入多输出正交分频多工模拟器。
正交分频多工:OFDM模拟器(外层函数)
create_channel:产生一个瑞利衰落信道复用,解的天线配置、正交分频多工结构、power-delay档案。
svd_decompose_channel:既然全网络知识是假设,在并行传输奇异值模式。这个函数分解这些频道模式。
BitLoad:适用bit-loading算法来实现预期的钻头和能量
(MIMO OFDM Simulator:
OFDM.m: OFDM Simulator (outer function)
create_channel.m: Generates a Rayleigh fading frequency-selective channel, parametrized by the antenna configuration, the OFDM configuration, and the power-delay profile.
svd_decompose_channel.m: Since full channel knowledge is assumed, transmission is across parallel singular value modes. This function decomposes the channel into these modes.
BitLoad.m: Apply the bit-loading algorithm to achieve the desired bit and energy allocation for the current channel instance.
ComputeSNR.m: Given the subcarrier gains, this simple function generates the SNR values of each channel (each singular value on each tone is a separate channel).
chow_algo.m: Apply Chow s algorithm to generate a particular bit and energy allocation.
EnergyTableInit.m: Given the SNR values, form a table of energy increments for each channel.
campello_algo.m: Apply Campello s algorithm to converge to the optimal bit and energy allocatio)
- 2012-04-30 10:09:02下载
- 积分：1
-
classifier
this program helps you to analyse pattern recognition classifiers using imported data
- 2013-08-11 22:51:52下载
- 积分：1
